Electronics Forum | Tue Dec 04 04:39:17 EST 2007 | laplooi
Who of the forum people is working with SPC Plus? Which people have problems with it en who's have tips for the users of SPC Plus? I'm working with it also 1 year, Its only friendly for statitistics, and when you are check a print, you can earlier r
Electronics Forum | Mon Aug 11 08:59:47 EDT 2014 | patel_daxa29
How do i generate YCD file from CircuitCAM? We have 6.2.2.1 version of CircuitCAM. I also need hel pprinting Visual aid in CircuitCAM. If you know something about this, Please Reply. Thank You Daxa
Electronics Forum | Tue Dec 01 17:40:45 EST 2015 | jackm
Thanks, Tom. I'll post with my results. It's been running for 2-1/2 hours now at the 100F setpoint. I may need to re-start the tuning tomorrow morning, since I don't want to leave it running at the higher temperatures overnight.
Electronics Forum | Tue Nov 13 04:47:19 EST 2018 | dhammika
hi Siplace Hs-60 defected due to below error Error- • Machine error:2271 Can bus: reception call aborted with time out seg:0 DEV: head 2 #:1 (this is not only head 2 ,error raise with all head interm
Electronics Forum | Wed Aug 18 01:29:20 EDT 2021 | korrapat905
Ok, now we found the problem source. IM-556; panel control was damaged that cuase no supply voltage out to reference sensor, S2/S2.1 I would to share, thank you.
Electronics Forum | Fri May 13 22:24:47 EDT 2022 | glasscake
Try adding blow after mount before head up if your machine lets you. Make sure your placing the part into the solder paste as that will add some holding force as well. If your tips are spring loaded you can do some 0.5mm additional mounting height.
Electronics Forum | Tue Jul 02 10:57:29 EDT 2019 | BigFuji642
Are the pinouts for the cable mirrored (like normal Male to Female DB pinouts)? Like the Male pins when looking straight at them are 1 2 3 4 5 and the female when looking straight at it is 5 4 3 2 1 Or is it that they are not mirrored and both ar
Electronics Forum | Thu Dec 02 11:14:49 EST 1999 | Dave F
Michela: Here's an outline for you to fill in the blanks: Policy Purpose Applicability Definitions Applicable Documents 1 Justification Of Spending 1.1 Request Preparation 1.2 Request Content 1.2.1 Summary Section 1.2.2 Capital Appropriation Reques
Electronics Forum | Tue Apr 10 16:41:21 EDT 2001 | slthomas
OK, you're talking about inline AOI doin' all the work for you, for a price. Fair enough. If you can't afford the inline post-print inspection equipment, though, I still think you can depend on the 2D inspection of the paste to tell you if you've
Electronics Forum | Thu Nov 17 20:51:16 EST 2005 | cangly
Morning Mike, We use Pb63/Sn37, Alpha Metal alloy. Solder pot is at 250 C. The profile of board after Preheat about 100 C, Lambda Wave about 220C (use both Lambda and Chip wave), DWell time 2.1s ~ 3s. Conveyor speed 1.5 in/min. We run by bare board a