Electronics Forum | Sun May 18 19:04:54 EDT 2008 | jmelson
OK, here's a sample component file : 1 0.1uF 0.00 1 24 1.00K 0.00 1 22 10.0K 0.00 1 3 1000pF 0.00 1 3 .001uF 0.00 1 25 1.0uF 0.00 1 2 100pF 0.00 1 30 10M 0.00
Electronics Forum | Thu Apr 29 13:33:13 EDT 1999 | KEVIN SIMPSON
| | | Hi everyone, | | | We started our first machine placed shield test today.We will be machine placing shields with in the next two months. I used a Fuji Qp242 today. There were no problems with pickup etc,. just vision errors. I'm sure we will
Electronics Forum | Mon May 07 11:09:49 EDT 2007 | davef
4 Fluxer Operation 4.1 Set-Up and Check-Out the Fluxer 4.1.1 Spray Fluxer Set-Up and Check-Out 4.1.1.1 Pass a sample unsoldered board through the machine. 4.1.1.2 Remove the board just after passing through the fluxer and the air knife. 4.1.1.3
Electronics Forum | Mon Aug 28 12:41:35 EDT 2000 | JAX
MoonMan, I'll take a crack at the list. Feel free to answer the ones I don't! 1. Solderability is a parameter which indicates how well a component can be soldered. As far as Solder Termination Coatings go, here are some up�s and down�s of a few. Ha
Electronics Forum | Thu May 09 17:07:56 EDT 2002 | davef
Troubles, troubles, troubles. If it weren�t for bad luck, I wouldn't no luck at all, eh? Tough business. Comments on your trouble are: * On machine vision errors from less than ideal capacitors: This is life. Reprogram your machine to either wid
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Sun Aug 08 11:15:32 EDT 1999 | Earl Moon
| | Mike, | | | | Got your message and those of others concerning PCB fab supplier evaluation and qualification check lists, etc. I have a severe problem here in WI as I can hardly access the internet, and when I do it is cut off abruptly for no goo