Electronics Forum | Wed Mar 13 09:08:40 EST 2002 | stockley
It is a little bit sad that I know this - be prepared for some confusision - this is not as simple as it might seem. Something tells me that the calculation of the tolerances for the nominal dimensions is a little inconsistent. As I recall the defa
Electronics Forum | Mon Aug 08 16:14:36 EDT 2011 | wmburke
We are building a plasma diagnostic to monitor MHD phenomena in tokamak. As part of the development, we need high-voltage, high-power RF capacitors to tune and match an inductive load. This application is similar to a small induction heater, with t
Electronics Forum | Fri Oct 01 06:02:43 EDT 1999 | Bach Huss
Hi, We are running 0402 component on the TCM1000 and we find that teher will be missalignment on 0402 Capositor. We have identified that the missalignment is caused by the wrong information from the vision system while doing vision centering. The sy
Electronics Forum | Tue Sep 17 07:42:27 EDT 2002 | cyber_wolf
Hi, We have a serious problem bending our 24mm tape covers. In particular we are feeding a 24mm 16 pitch tape on a 24mm P8 feeder.The component is a plcc28,the tape cover is a AMCD3107 5.0 When the tape covers come in from Fuji the fingers that cove
Electronics Forum | Thu Jun 03 17:43:34 EDT 2004 | g2garyg2
Hi Doug, Read your inquiry. My company PRO-MATION has some exciting technologies available for both top side and bottom side selective laser soldering. Our work cells are great for low volume / high mix environments and are capble for both Tin Lead
Electronics Forum | Wed Jul 21 01:27:17 EDT 2004 | simmcircuits
Hi, I need help in aligning the stencil and the board on an MPM AP25. I have no calib jig and stencil what I did was edit w/dos editor the file ap.cal. It seems to be working OK now just a little bit of offset but what I'm concerned is the software t
Electronics Forum | Thu Jun 29 10:45:46 EDT 2006 | stepheniii
We have an ERSA Versaflow Ecoselect selective wave soldering machine. It works well except it needs nitrogen. You can't even move the table around if your nitrogen tank is empty. The spec sheet says Required degree of purity: Nitrogen liquid 5.0
Electronics Forum | Fri Jul 09 23:45:22 EDT 2010 | dman97
I have a CP642 machine that always gives me a Station 17 or Station 19 nozzle error when the machine selects the 2.5mm 3.7mm or 5.0mm nozzles. It always throws an unknown nozzle station 17 error after all the heads have switched to the above mention
Electronics Forum | Thu Jan 13 15:17:27 EST 2022 | goseese
Thank you very much I will look for something moving, loose or getting pinched when the table moves. -- Update -- checked every single connector, all the purple cables/connectors too. Everything it tight and not getting hung up. Checked all the
Electronics Forum | Wed Jul 02 13:26:50 EDT 2003 | Terry Saunders
Hi, Terry!� Espi on our staff passed on your request to me.� I have attached a list of companies that offer previously used equipment.� You may want to try one of them.� You can also post this question on our Web site at http://www.smta.org.� Click o