Electronics Forum | Sun Jan 17 19:21:06 EST 1999 | Wayne Bracy
To ALL: Guess I have indicated that I am not supportive of Trade Shows in general. Make it very clear that I do not support Nepcon West, East, Southwest, Philly, Japan, or UK. Of all of them I feel that there should only be Nepcon West. As for
Electronics Forum | Wed Jun 10 18:40:00 EDT 1998 | Earl Moon
| I am looking for the Industry standards on vias. Are they required to be plated with solder or is copper plating enough? What about reliabilty with either one? Also, if tenting the via is required should it be copper plated or solder plated over
Electronics Forum | Tue Jan 14 20:32:41 EST 2003 | davef
There's just about 4 beezillion companies that give solder training. Some are: * BEST Rolling Meadows, IL 847-797-9250 Bill Westmoreland (bwestmoreland@solder.net) http://www.solder.net/ * Circuit Technology 340 Raleigh St Holly Springs, NC 27540 (
Electronics Forum | Thu Mar 30 12:13:10 EST 2006 | Tech
Obviously you are not as experienced as you think so I will help you out a bit.You are correct on the size of the wrench. I was trying to recall from memory but the wrench size is 8mm. The odd size I recalled came from the other side of the wrench th
Electronics Forum | Wed Nov 16 14:44:31 EST 2011 | olddog
Bobpan, thank you for your speedy response. As to the items you noted: 1. I did a test of Funct 30 for the first 5 nozzles, 2 times each as follows: noz1 Ht=215 & 219, center=1005 (all nozzles all tests), run out 2.2 & 2.7. Noz2 Ht=228 &228, runout=
Electronics Forum | Tue Jan 19 12:17:13 EST 1999 | marc p
| To ALL: | | Guess I have indicated that I am not supportive of Trade Shows in general. Make it very clear that I do not support Nepcon West, East, Southwest, Philly, Japan, or UK. Of all of them I feel that there should only be Nepcon West. |