Electronics Forum | Thu Oct 12 19:47:24 EDT 2000 | Dave F
Fraser: You're correct!!! We did our analysis on paste rather than glue and I missed that when changed things to respond.
Electronics Forum | Tue Oct 03 13:14:37 EDT 2000 | jarnopy
Hi, You are right, but if you don't have very fast ship shooter then i think that dispenser is better. I have experience on both variation. If you have a line dispenser then speed is quite good. Most often it is sufficient. And unfortunate often qual
Electronics Forum | Mon Feb 11 13:41:12 EST 2008 | sliebl
We use EFD pneumatic dispensers. Several are second hand from our favorite online auction site. I just checked on there and there are 3 units currently less than $50. Have the bean counters where you work get you one. Tell them your hand hurts from u
Electronics Forum | Thu Oct 12 11:08:20 EDT 2000 | Fraser
Dave, Why on earth would you want to use a stepped glue stencil?. If you print slightly off contact the hight of your glue deposition will be roughly half the width of your adhesive aperture width so if you want a 10mil high deposit use a 20 mil ape
Electronics Forum | Thu Oct 12 22:16:59 EDT 2000 | Dreamsniper
Hi Guys, I'd like to share this to all of you...you can start playing with the rests...Stated prices, if not indicated, are in Aussie $ or Singapore $. Stencil Printing Adhesive Pros a) Less Capital Equipment Cost (Short Term). In reality it is f
Electronics Forum | Fri Apr 23 14:59:14 EDT 1999 | Chrys Shea
| Has anyone had trouble waving and gluing 0603 R's and C's? At my company, our designers have "opened the floodgates" on bottom-side 0603's. | | We've got an EPK+ with rotary chip and omega wave but can't seem to get skip-free soldering on these g
Electronics Forum | Fri Apr 23 15:04:44 EDT 1999 | M.T.
| | Has anyone had trouble waving and gluing 0603 R's and C's? At my company, our designers have "opened the floodgates" on bottom-side 0603's. | | | | We've got an EPK+ with rotary chip and omega wave but can't seem to get skip-free soldering on t
Electronics Forum | Tue Oct 03 20:35:23 EDT 2000 | Dave F
1. Throughput * Dispenser: Slower, may loose 70% of tact on fast chip shooters * Printer: Can be put in front of and use fast chip shooters effectively 2. Rework Rate ???? Deposition control???? * Dispenser - High control over amount paste - Coplan
Electronics Forum | Fri Oct 13 13:44:03 EDT 2000 | Mike McMonagle
You can achieve a wide range of dot heights when stencil printing by using a polyimide stencil along with a .040 snapoff. Loctite has a system for this that they call Varidot, by varying the size of the apertures in combination with the .040 snapoff
Electronics Forum | Fri Apr 23 15:33:50 EDT 1999 | C.K.
| | Has anyone had trouble waving and gluing 0603 R's and C's? At my company, our designers have "opened the floodgates" on bottom-side 0603's. | | | | We've got an EPK+ with rotary chip and omega wave but can't seem to get skip-free soldering on t