Electronics Forum | Thu Nov 17 17:44:19 EST 2011 | bobpan
Tim, 1. You dont need the vacuum verify if the quadalign is working properly. If you have the part quad-aligned and dont have alignment type at 0 it will never 'not' place a part. More or less...the vac verify was needed for the chucking machine (3c)
Electronics Forum | Wed Jul 28 22:36:29 EDT 2004 | kent_peterson
Yes to what John said. Especially about finger oil on the bulb or you will replace them often enough to burn out your retina. Thought about using the plaster but never had a big problem with alignment.
Electronics Forum | Mon Feb 04 11:01:44 EST 2013 | bobpan
The way its supposed to work...is....when you do a function 30 the z axis should step down until the nozzle tip is seen in the quad align or laser align. The readout should have a nozzle height but if its the earlier firmware for the machine it might
Electronics Forum | Thu Aug 16 14:29:00 EDT 2012 | bobpan
Sounds to me like a dirty quad-align. If you have cleaned the lens and have the same results then you may have dirt on the inside of the quad-align. The only fix is to replace it or blow it out with an air gun. Unfortunately it is not easy to tell if
Electronics Forum | Tue Nov 14 00:08:24 EST 2000 | George
Hi Jax, The alignment pop up only on some parts and it's random axes. This happens every prototype run that I need to adjust the alignment of some parts. Fiducials are correct and okay. Also had done calibration on our machines. I really suspect that
Electronics Forum | Wed Sep 26 07:40:30 EDT 2012 | highmillr
I had this problem at another plant with the UP 2000....When the machine resets, The left and right side of the conveyor misaligns, causing the conveyor to be tight on the loading end and boards falling out of the unloading end. or vise versa...the t
Electronics Forum | Tue Jul 28 09:59:23 EDT 1998 | Philips Technical Support
| We have a CSM84V here and the nozzle changer hasn't worked in several years. Because we aren't liked by anyone and won't get another machine | for a while, we need to get the changer working again. Philips said that the nozzle isn't going up all t
Electronics Forum | Wed Jun 02 13:42:48 EDT 2004 | black5629
I am using a board w/fiducial, still problem. Now is Vision Align is same as Teach vision. My teach pull-down menu doesn't show Teach vision, it shows Vision Align, Vision Inspect and etc. It is a new m/c for us. I can use any help. Thanks
Electronics Forum | Thu May 20 09:47:25 EDT 2010 | pforister
Is this a single head Quad IVc or a dual headed line? if it is a dual line you can swap the align cards in the front bay between the two heads and see if the symptom follows. The card on the far right is a transport card, shouldn't need to swap tha
Electronics Forum | Sun Feb 10 16:04:28 EST 2013 | marcelorotofrance
Recently I posted a query about my Quad IVc align problem. At the same time, I am working with the feeders we have received with the machine. These are from different origins and antiquity. Some are faster than others. The slower ones have discrete t
