Electronics Forum | Thu Nov 30 11:32:07 EST 2006 | fastek
I have the feeling FishingFool's situation or dilemma is not a PCB Assembly related application......or at least it's not a component placement related application with auto board loading and fiducial recognition. That would be too easy to figure out
Electronics Forum | Tue Jan 30 14:27:50 EST 2007 | Sundaram
I am a Quality Engineer at a CM in VA. Can some one share their knowledge/ process on how to inspect the PCB after application of the solder paste? Also the major issues / defects that we might experience after the application of solder paste on the
Electronics Forum | Mon Feb 05 09:48:51 EST 2007 | George
Good morning, What is considered "high frequency" ,.i.e. Mhz,GHz,etc., when we talk about possible issues with NO-clean flux residues and product's application? I appreciate your help on this... Have a good one! George
Electronics Forum | Wed Feb 07 23:30:13 EST 2007 | KEN
I have a customer who runs A-D applications with 5GHz analog and it is 100% no clean. The only answer that will be acceptable is what works for your circuit design.
Electronics Forum | Thu Mar 08 10:35:59 EST 2012 | capse
hi, I represent Epoxy Technology in the southeastern US states. They have a nice PCBA application guide. Here is the url for the PCB Guide; http://www.epotek.com/pcb_applications.asp
Electronics Forum | Sat May 18 21:52:30 EDT 2013 | kumar_antom
Hi guys, Whats actually Delta T ? As i know,its applicable for reflow profiling. Recently my superior asked me whats the Delta T for heating settings on my reflow ? Does Delta T applicable for heater setting on my reflow ? Pls advise as i m puzzl
Electronics Forum | Thu Dec 18 10:12:47 EST 2014 | capse
I represent Epoxy Technology. They supply both epoxies and ployimides for this application. You reach their Applications Support group at (978) 667-3805. If you are located in the southeast you can also contact me.
Electronics Forum | Fri Jun 21 03:07:28 EDT 2019 | gregoryyork
REL alloys from Aim solders maybe worth looking into for this application. May I ask what your profile on reflow is like please, especially peak
Electronics Forum | Thu Jul 25 14:32:55 EDT 2019 | bulur
What does flux acid value means in SMD and PTH applications? Is it higher acid values better for each application?
Electronics Forum | Wed Oct 09 17:58:56 EDT 2019 | SMTA-Joe
I'm not sure there is so much of an advantage as much as it may be just easier to apply? New to dispensing, especially in this application, so I'm mainly brainstorming at this point. I will look into the manufacturers you listed though. Thanks for