Electronics Forum | Fri Sep 17 15:20:52 EDT 1999 | Earl Moon
| HI everyone, | | We are using a Siemens ap-25 screen printer, in the past we have not had any problems with adhesive placement until a couple of weeks ago. It seems the x axis has decided that it should be set somewhere between .00085 and .001
Electronics Forum | Mon Feb 04 11:01:44 EST 2013 | bobpan
The way its supposed to work...is....when you do a function 30 the z axis should step down until the nozzle tip is seen in the quad align or laser align. The readout should have a nozzle height but if its the earlier firmware for the machine it might
Electronics Forum | Fri Nov 02 22:30:04 EDT 2018 | ecdave
Hello. Hoping to find help troubleshooting z axis issue. Initializes OK, and runs a bit sometimes not going all the way down to reach feeder, misses part and tries again, usually successfully, before ultimately stopping for "F-MOT-MOVE INDVACWAIT Z/2
Electronics Forum | Fri Sep 17 21:25:00 EDT 1999 | Rob
| | HI everyone, | | | | We are using a Siemens ap-25 screen printer, in the past we have not had any problems with adhesive placement until a couple of weeks ago. It seems the x axis has decided that it should be set somewhere between .00085 an
Electronics Forum | Thu Jul 27 17:18:43 EDT 2006 | seth
Yes, I have but if I don't then I won't be able to reference run.
Electronics Forum | Mon Jul 31 21:33:58 EDT 2006 | seth
What is the distance from the reader to the segment, and can you use a filler gauge to set the gap or is there a special tool needed?
Electronics Forum | Tue Feb 01 13:21:34 EST 2011 | cyber_wolf
Try switching to a different board and see if the error goes away. If it does, it has something to do with one of the loader sensors not being made.
Electronics Forum | Mon Feb 04 06:48:50 EST 2013 | bobpan
Do a function 30 on the hht and you should get a nozzle height of around 200. If its not and its around 1 you have something on the quad align lens and you will have the exact problem you are having. Hope this helps... Good luck
Electronics Forum | Sun Feb 10 15:14:25 EST 2013 | marcelorotofrance
After an in depth examination, I found that the problem was not a defective connector as I thought in the first place. Actually is a broken through-hole on the Quad Align sensor. I requested a spare part to PPM. Mr. Bobpan, thank you again.
Electronics Forum | Wed Oct 26 22:31:48 EDT 2022 | sarason
Broken wire connecting to the encoder on your servo, or anyware else in the feedback loop?, bent up encoder? sarason
