Electronics Forum | Tue Nov 01 14:40:22 EDT 2022 | glasscake
Also to diagnose if it is the correct axis go to the "calisim" or the "axis position" option in utilities and get to the "current position" menu. Estop the machine and move the relevant axis by hand and see if the encoder count goes up.
Electronics Forum | Wed Feb 23 15:19:49 EST 2005 | Dilbert
I don't work on quads but I can give you some things to look for... Each of the moving axis work off a motor that is controlled by a "drive". Some of these drives have a fault or error output that is connected to the motion controller. One of your
Electronics Forum | Mon Sep 30 16:36:00 EDT 2013 | richardconnell
I have a Universal Instruments Corporation TAB Bonder. Oldish machine. Initial fault on machine : - "Axis Head 1 Z DAC Limit error during move absolute command" Other fault seen after we reset power, Zeroed axis etc. - Axis Head 1 - Z error not re
Electronics Forum | Sat Feb 16 11:36:09 EST 2019 | robertorocco
When the camera moves to the bord stop position, or to the fiducial position, the following message appears "Axis camera error - out of time" some indication on how to solve the problem? Thanks
Electronics Forum | Tue Oct 25 09:20:10 EDT 2005 | meritajs
Hi, We have problem with y-axis offset at YM84 After setting the ORIGIN machine operate exactly but after sometime y-axis recieves offset bis 5-10mm.After repeated setting ORIGIN Y-coordinat became exact. The same things take place if we operate in W
Electronics Forum | Thu Jun 02 15:16:54 EDT 2016 | dilogic
I did try to null the axis - no improvement. I have AMC software and tried (almost) everything related to electronics (except for changing linear encoders, but this seems to be OK - when I move axis manually, position numbers change smoothly). It loo
Electronics Forum | Mon May 19 09:56:57 EDT 2008 | aj
all, The placement was off on one panel ( 4 up ) out of the batch. It was off by approx 1mm in the y-axis. No obvious faults found with machine. Any experience of such problem - I am guessing this is a sign of something wearing on the machine or s
Electronics Forum | Mon Oct 13 13:24:21 EDT 2014 | rgduval
Deni, Yep, we found that one the other day, too. And, yes, axis mounted is set to 1. We tried setting it to 0, saving, then back to 1 (again, hoping to clear a software flag/fault, if that's what it is). Thanks, ..rob
Electronics Forum | Wed Jun 03 21:49:27 EDT 2020 | bboyer
Well, we finally got the machine to power up and fully boot, but now we are having issues with zeroing the axes. X, Y and Theta zero OK, and the board conveyor runs, but when it tries to zero the PWC, the rail moves to the rear of the machine, hits
Electronics Forum | Wed Sep 30 20:35:51 EDT 2020 | erici
Hi all, was wondering if you have any ideas on how to correct the problem we are encountering with our S25 machine. The machine is giving an X-axis counting error at gantry 1. I replaced the x-axis linear reader and the linear scale as well, but st
