Electronics Forum | Sun Sep 25 16:02:59 EDT 2005 | mark
The calibration was ok. When i switch off the back camera and use front one everything is ok. Is it true that when Topaz use back line camera after checking the components the machine rotates the components 180 degree?. Mark \
Electronics Forum | Sat Dec 24 07:48:52 EST 2005 | ams_gen
Hello, I need to rework a thru hole DIP mounted on a metal backed FR4. It is difficult to remove the FR4 board from the metal back since it is riveted. Is there a simpler way to takle this? Thnx
Electronics Forum | Thu Feb 16 03:43:54 EST 2006 | aj
hi, we tried to introduce form-flex a few years back and it caused more problems than it fixed. Switched back to pins and no problems. It might have improved since but I would be reluctant to get them again unless I was given a 6 month trial!! aj
Electronics Forum | Tue Jun 06 16:50:33 EDT 2006 | pjc
Push Back !! Check out this article: http://www.circuitnet.com/web/article_20181.shtml
Electronics Forum | Thu Aug 03 09:37:33 EDT 2006 | Simon
Curious if anyone knows... When switching back and forth from Leaded paster to Lead free if cleaned with alcohol can the same squeegees be used? If so could anyone direct me to any links that would back this up. Thanks, Simon SMT Tech, Edge Tech Indu
Electronics Forum | Thu Aug 31 09:07:48 EDT 2006 | AR
Hi Anybody know of a company/institution who can perform component tape peel back force testing, preferably in the Scandinavian region?
Electronics Forum | Fri Dec 22 09:47:18 EST 2006 | realchunks
Check your battery back up if you have it. If I remember correctly, you may have to manually switch your wiring to by pass a dead battery back-up.
Electronics Forum | Wed Apr 30 11:41:55 EDT 2008 | gemengr
It back running now, after shut it off over night, it power back up,look like the heat sensor under of 4 resistors is start getting bad.But i'll by pass it, if it happen again. Thank you for your in put.
Electronics Forum | Tue Aug 19 14:24:22 EDT 2008 | shanenaturalpoint
My first problem is that when the unit homes, the print carriage seems to be traveling too far back. After the carriage reaches its mechanical limit, it continues to try and move back, eventually throwing up a print carriage error. Any ideas?
Electronics Forum | Fri Mar 13 05:12:06 EDT 2009 | geb
Hi, Does anyone have problems with the cover tape not peeling back on the 8mm wide feeders. We often find that particularly at the start of the job, the cover tape doesn't peel back causing mis-picks. Thanks, Grant