Electronics Forum | Thu Oct 26 12:27:40 EDT 2000 | Dave Cunningham
What guidelines would you suggest for an assembly house concerning the baking of bare PCB's (assume FR4) and flexes/rigid-flexes before assembly.
Electronics Forum | Wed Feb 20 09:29:19 EST 2008 | mun4o
ni, I had similar problem too.I bake PCB in SW mashine - about 8h ,T=90 C.Problem is in the base material of PCB - there are moisture in the material.After my complaint to PCB factory , they change material and the problem disappear.
Electronics Forum | Thu Jan 17 20:33:05 EST 2002 | ianchan
Hi, Can anyone help explain the benefits/disadvantages of bareboard pcb baking, as part of the pre-heat conditioning, before the bareboard pcb use in SMT production run? The pcb board is 200mm x 240mm panelized pcb board, and has 28 smaller pcb boa
Electronics Forum | Mon Jan 08 10:41:50 EST 2007 | jaime39
If you bake the boards at 125 degrees celcius for about 4 hours it should work. I would also suggest that you talk to the PCB supplier to take care of this baking for you. NOTE: PCB�s with an Entek or any other type of OSP finish should not be baked.
Electronics Forum | Mon Apr 18 20:44:30 EDT 2005 | davef
Charly: Why do you "need to bake the PCb due to moisture issue", if you're not going to use the board? Why bake the board, just to put it back in storage, absorb moisture, and require baking again?
Electronics Forum | Thu Feb 24 14:58:11 EST 2000 | Greg denham
Does anyone have any information on baking boards to remove moisture before reflowing and waving assemblies? I've been told that we should do this to stop such problems as delamination of boards, blow holes, solder balls, etc. I don't know have any e
Electronics Forum | Thu Feb 24 18:08:42 EST 2000 | Travis Slaughter
Baking boards, especially multi layer, will help with blowholes and delimitation, but not with solder balls. Normally about 120c for 1 hour or so is sufficient. I usually will not go to this trouble unless a board has proven to be a problem or if th
Electronics Forum | Thu Feb 24 14:58:11 EST 2000 | Greg denham
Does anyone have any information on baking boards to remove moisture before reflowing and waving assemblies? I've been told that we should do this to stop such problems as delamination of boards, blow holes, solder balls, etc. I don't know have any e
Electronics Forum | Thu Feb 24 18:08:42 EST 2000 | Travis Slaughter
Baking boards, especially multi layer, will help with blowholes and delimitation, but not with solder balls. Normally about 120c for 1 hour or so is sufficient. I usually will not go to this trouble unless a board has proven to be a problem or if th
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830