Electronics Forum | Thu Apr 25 10:00:25 EDT 2019 | SMTA-Gregory
I would suggest you look a the Sikama International Falcon 5 benchtop reflow system, Economical, reliable and good value. You may be able to get one on the used equipment market.
Electronics Forum | Fri Sep 25 06:39:15 EDT 1998 | Wayne Bracy
| Does anyone know where I can get conductive benchtops? NOTE: I don't want a mat and I'm already using (and unhappy with) a laminate surface glued to a wooden table. Any and all info would be very much appreciated. | BTW: I'm also looking for conduc
Electronics Forum | Sun Sep 20 17:54:26 EDT 1998 | Wayne Bracy
| I am looking for a small benchtop rework station for replacing bad QFP132's as well as a variety of SO8 to SO20 components and 1206 chips. I've been looking into some IR heating equipment as well as hot air tools, but have little experience with s
Electronics Forum | Mon Sep 21 10:49:05 EDT 1998 | Ben Salisbury
| | I am looking for a small benchtop rework station for replacing bad QFP132's as well as a variety of SO8 to SO20 components and 1206 chips. I've been looking into some IR heating equipment as well as hot air tools, but have little experience with
Electronics Forum | Fri Jun 24 04:04:43 EDT 2005 | Rob
Hi, Sorry, should have been more specific. We're looking for one of those benchtop/very small footprint machines to go with a support rail hand printer & benchtop reflow for our design lab to use for low volume prototypes. Something you can plug i
Electronics Forum | Wed Dec 17 16:49:39 EST 2003 | adlsmt
Take a good look at Yestech. The in-line machines are under $100K with off line software. I think about $80K if you dont need side cameras. We replaced our Agilent SJ-10 with one and have been very happy with it. Last I knew the good benchtops out th
Electronics Forum | Tue Jan 13 15:16:12 EST 2004 | drewhmi
A small benchtop system uses a mask, tooled for your part, to arrange the solder spheres onto the BGA, after it has had the excess solder heat-vacuumed off and a new layer of flux applied. The spheres are poured into the cavity, excess decanted off.
Electronics Forum | Wed Nov 10 11:21:37 EST 2004 | jmedernach
Hi Folks, Does anyone out there know the names of the manufacturers of batch style vapor phase reflow systems. I'm not interested in anything in-line. I'm looking for relatively small footprint systems. I've come across Wenesco and Sintronex. Doe
Electronics Forum | Wed Nov 10 11:21:39 EST 2004 | jmedernach
Hi Folks, Does anyone out there know the names of the manufacturers of batch style vapor phase reflow systems. I'm not interested in anything in-line. I'm looking for relatively small footprint systems. I've come across Wenesco and Sintronex. Doe
Electronics Forum | Thu Feb 24 13:52:16 EST 2005 | deyo
I have a quad vmp20b benchtop printer that keeps blowing out the table up\down control FETS. Anybody have any idea what component is before or after these fets that could be causing this? I metered all the surrounding components nothing was out of t