Electronics Forum | Wed Sep 25 13:38:35 EDT 2002 | finepitch
Yannick, If we leave the 201 issue aside; have you checked where those BGA pads are connected to? Could those be power/ground balls connected to large (difficult to heat up) planes by any chance? Erhan
Electronics Forum | Sat Mar 15 01:03:10 EDT 2008 | callckq
All, What if BGA solder crack do exist after the shock test? Its happen at the corner of the BGA. Base on your experience, what are the potential root causes? Thanks, Sean
Electronics Forum | Thu Sep 07 03:57:39 EDT 2000 | Steven Cheung
Does anyone know of a freely-available document which discusses the main considerations of BGA assembly and inspection (x-ray?). l need to know about pad sizes and inspection standards and when to underfill and when not to etc.. l am looking at ass
Electronics Forum | Tue Jun 28 00:11:30 EDT 2016 | ricoloverde
Hi, new to the forum here. First Post! Ive been using a Samsung sm482 for about 2 years and recently got the heads up that we will be getting a project soon with a BGA chip. Im wondering if anyone on here uses the SM482 for BGA and if so, can offer
Electronics Forum | Wed Sep 25 06:56:16 EDT 2002 | CH
U may check your profile ramp rate. The flux may evporated and look like cold joint
Electronics Forum | Thu Jul 06 13:36:37 EDT 2006 | SWAG
We've had much trouble with flex circuits. As previously mentioned, you must have local fids for the board or the BGA itself (if panelized). Other troubles we experience are drilled holes for pinned connectors. Unless the PCB manufactur has some w
Electronics Forum | Tue Jul 11 11:18:06 EDT 2006 | dougs
Thats a good point SWAG, i'll look into that for the next run of these. cheers
Electronics Forum | Sat Jul 29 02:46:33 EDT 2006 | rogerw_tech
hi everyone what does ball grid array and pin grid array mean? thank
Electronics Forum | Fri Aug 18 11:50:31 EDT 2006 | H. Jablohmie
Do they have Wikipedia in foreign lands? http://en.wikipedia.org/wiki/BGA cheers, Haywood
Electronics Forum | Tue Mar 14 05:02:35 EST 2000 | emmanuel
I am to implement PBGA, and i am looking for PCB surface finish informations. A lot of technical reports are specifing NiAu finishing because of flatness property. Because of leads shape, I though that BGA doesn't need flat pads like QFP. Is it false
