Electronics Forum | Wed May 30 11:08:39 EDT 2007 | bartlozie
If you are use to this kind of work, you can repair/replace these components with a simple hot air blower, (�100) Get a good air and temperature controlled hot air blower, and a skilled operator, mount a thermocoupler on a testboard, and learn the t
Electronics Forum | Mon Sep 01 04:55:20 EDT 2008 | benefon
Hello all Our Omni 5 has given the 'Cooling module high temp' warning twice during the past month. I suspect that the blower motor is the culprit but have not been able to verify this because the oven has started up normally after acknowledging the
Electronics Forum | Thu Aug 06 19:37:45 EDT 2009 | voytek
I am looking for replacement pump motor for CAMALOT 1818 or company which is able to repair it. Motor manufacturer is MICRO MO P/N 3042W024CR. Thank you,
Electronics Forum | Wed Sep 11 17:16:17 EDT 2013 | saied
Hello, We would like to order this spare-part blower motor electrovert omni Excel for Speedline Technologies Electrovert, type: Omni Excel 7 Serial: 476219 Date: 4/04 and we would be thankful if you provide us the Service manul for your prod
Electronics Forum | Thu Jul 23 13:23:45 EDT 2020 | bmalhi
Small components blown issue could be due to one of the below. - Process issue; Make sure solder paste is fresh, if flux is drying out it will not hold parts properly. Check downward pressure of Pick Place. SOT may have to be pushed a little harder i
Electronics Forum | Tue Jan 04 20:41:08 EST 2022 | jzrelcom
Just had the x motor repaired and the friction measurement went from ~17 to ~33
Electronics Forum | Thu Sep 15 13:52:40 EDT 2005 | pr
We had 2 at my last company. As I recall we had a hell of a time with bad blower motors. I'm not sure how you'd check on that, but maybe that problem has been fixed by now (it's been a few years). good luck, pr
Electronics Forum | Tue Aug 01 15:02:06 EDT 2006 | BillB
Had a Treiber in a past live. Had a standard air knife in the first section and then a turbine blower with a stainless steel air knife with about 15-horse motor. Had some problems with bearing on the turbine Make sure the exhaust hot air doesn't con
Electronics Forum | Wed Nov 07 06:47:52 EST 2012 | leeg
I am having issues whereby a zone on my heller oven goes through a stage whereby it never seems to stabilise, I have checked the blower motor, changed the SSR and my next step will be to check the heater element, does anyone have any idea what type o
Electronics Forum | Wed Oct 26 18:25:13 EDT 2005 | darby
The encoder on the Y axis motor is almost certainly kaput. Debris from the wear of the motor brushes or whatever else can find its way onto the encoder and give an ever increasing false pulse. The axis will start OK but progressively go out of whack