Electronics Forum | Wed Dec 27 10:55:47 EST 2006 | SWAG
I don't know much about BTU but we had a very similar problem with a Conceptronics and it turned out to be one of the 120V power supplies. Our machine had two of them (the same as you would find in any PC). Easy to test them although they can be fl
Electronics Forum | Wed May 24 08:02:09 EDT 2006 | geb
Hi, Can anyone recommend a leadfree recipe for a BTU VIP98 i.e. which temperatures for which zones & belt speed? I appreciate that there will be a difference from one oven to another, along with different board sizes, but would like a good starting
Electronics Forum | Tue Mar 22 12:04:31 EST 2005 | John S
Thanks for the advice. In this scenario we are designing our own product. Currently we are building at a prototype level with no appreciable wait between reflow passes. The part in question is a 64 pin QFP. We use a BTU VIP 98 with edge conveyor.
Electronics Forum | Mon Dec 25 12:17:57 EST 2006 | KEN
first, does the recipe have the heat and conveyor boxes checked? If no then it does nothing. second, have you pressed the round green switch? third, are there any alarms in the alarm box? Do you have a controller link fail? Verify the cable is p
Electronics Forum | Sat Dec 30 00:02:10 EST 2006 | Mats
Hi, A couple of another things is to check: * The cooling water supply (assuming that your oven has this feature). * The fans (Just open the hood and check if every fan, up & down is running). * Open the back panels: and you should see some "black"
Electronics Forum | Thu Jan 04 04:49:51 EST 2007 | geb
Thanks, Chunks. Your first post was correct, it turned out to be the battery. That is that problem solved. Unfortunately I have now got an error message saying Flux Management Failure. Is this just a coincidence? It sounds like something to do with t
Electronics Forum | Mon Sep 13 15:47:44 EDT 2010 | dox
Somebody pressed the system set button and now the machine has an e-stop,lid open, and extraction error. checked the control relays and all is OK except one is not switching on. The cable comes from the FCU unit so suspect some config or settings are
Electronics Forum | Fri Dec 22 09:19:11 EST 2006 | simonlee
Our VIP98 oven just refused to do anything this morning, no previous history of problems. Conveyor and heaters do not start up. None of the Solid State Relays in the back of the unit are operating, although we can make them switch by wiring up to t
Electronics Forum | Fri Dec 07 02:10:26 EST 2007 | mpolak
Hi, Could you guys verify my BTU VIP98N oven settings for lead free process. At the moment as my standard profile im using these settings 140 160 180 207 205 220 257 same temps for bottom and speed 50cm/min. Has anyone got same oven and could
Electronics Forum | Tue Jun 10 18:48:42 EDT 2008 | mefloump
We run 2 lines: Line 1 has a Dek 265, GL5, CP43, QP242E, and Heller 1900W; Line 2 has an Ekra X4, GL541, CP643E, QP242E, and BTU VIP98N oven. Soon both lines will have new Ekra X5 screen printers and the BTU replaced with another Heller. Works for us