Electronics Forum | Fri May 07 15:08:51 EDT 1999 | ANIROOTH
| | I would like to know if someone aleady have problems with Ceramic Capacitors SMD in In-Circuit Test (see below)and how did you solve this problems ? | | | | PROBLEMS | | 1 - Only one kind of capacitor (2n2F), of all capacitors on board, sometim
Electronics Forum | Tue May 05 09:58:51 EDT 2015 | anirudh_thabjul
hi everyone, I have done with my PCB Prototyping. I need to Prepare a Bill of Materials(BOM) for my PCB Assembly. I have one doubt regarding selection of SMD Capacitor. -My Question is For Example, I have to use 0.1uF capacitor on my PCB board.In
Electronics Forum | Sun Apr 04 10:16:16 EDT 2004 | cyclopsn
I'm involved in backplane manufacturing process. There are about 10 electrolitic capacitor assembled in my board.These capacitor are soldered using a selective soldering machine. My problem is that these capacitor will charged up and failed as short
Electronics Forum | Thu Mar 04 10:21:55 EST 1999 | Igmar
Can someone please advise me to the rework procedure for removal and replacing Ceramic Chip Capacitors (e.g. 0805, 1206, etc.)? Is it necessary to pre-heat ceramic capacitors before soldering them onto a PCB with a soldering iron? Is this just a rec
Electronics Forum | Thu Sep 03 11:45:34 EDT 1998 | Dave F
| I am in need of possible causes and solutions to capacitors that are failing in the field. | Are there issues in our process that need to be | checked? | Some people said the problems are due to improper | storage. Others say it is thermal stre
Electronics Forum | Tue Dec 30 20:48:31 EST 1997 | Tom Gervascio
Has anyone had any experience with thermal shocking and cracking of SMD capacitors during the rework process? My company was advised to preheat capacitors to 125 C at a rate of 2 C/sec before replacing them onto boards. Would this maybe degrade c
Electronics Forum | Wed Mar 20 23:28:34 EST 2002 | Mahesh K.R.
I have some questions on this. What is the power rating of the power supply? In power supply where are you using the capacitor? What type of loads you connect to the power supply? If it is a simple 50Hz rectifier, There is no option. You have to us
Electronics Forum | Mon Feb 24 19:16:38 EST 2003 | Neil
Brad, This is a common problem and may relate to the design of the board. In all cases when a device such as a capacitor is place near the edge of the board and the board must be de-panelled, the capacitor must be parallel to the break line. If the
Electronics Forum | Thu Apr 17 14:14:17 EDT 2003 | davef
Takfire Questions are: * Why does your customer think the capacitor is the issue? [What are we thinking? Of course the capacitor is causing this voiding problem. What else could it be?] * What are the type, construction, end-cap material and plati
Electronics Forum | Mon Nov 22 10:57:25 EST 2004 | davef
On the dendritic growth over the top of the capacitor: We agree that your capacitor supplier probably did not do a very good job of cleaning process residues from their device. On the metallic fragments under the capacitor: This sounds like solder