Electronics Forum | Sun Aug 13 22:26:01 EDT 2017 | dawson
Anyone who knows how to prevent such > flaw? > > Tombstones are those lifted components > from one sides. This results in costly and > time-consuming amounts of touch-up and re-work > after the assembly is completed. For the > customers, this e
Electronics Forum | Wed Jul 15 13:33:56 EDT 1998 | Don Welling
I am looking for information on the amount of stress a component sees during the depaneling process. I am currently specifying a new piece of depaneling equipment and I have not found any studies that quantitatively compare the amount of stress diff
Electronics Forum | Thu May 22 18:47:12 EDT 2003 | russ
I would assume we are talking about a radial leaded electrolytic cap? We use Electronic grade RTV (Dow corning 3145). It sticks good and can be removed if necessary. It is also pliable so you don't have to worry about CTE or other stresses that may
Electronics Forum | Tue Jan 04 19:55:46 EST 2000 | Rob Thomas
Hello Yosef, non woven aramid reinforced pcb's are used where is a need for low CFT (coefficient of thermal expansion). Traditionally aramid pcb's were used in military applications in order to reduce the stress/failure rate of solder joints during
Electronics Forum | Tue Jun 02 14:32:58 EDT 1998 | Chris Fontaine
We have experienced poor adhesion of acrylic conformal coating to plastic bodied IC�s. The observed symptoms of this are a blistering or lifting of the coating at the surface of the component, although peel testing has revealed that this is not alwa
Electronics Forum | Fri Jul 29 19:12:30 EDT 2005 | Jason Fullerton
In the true sense of the term, tombstoning can only occur during reflow. Now, if your solder joints are cracking during thermal cycling and opening on one end you still have a problem - it just isn't "tombstoning". What laminate are you using on yo
Electronics Forum | Mon Aug 20 15:53:52 EDT 2007 | erhard
Manufacturing already tried to get a design change but no chance. I guess because the designer is afraid the components could get bent too much if they are mounted with a stand off. Of course everyone who has to manufacture this fist sais: why don't
Electronics Forum | Fri Jul 17 11:57:25 EDT 1998 | Justin Medernach
| I am looking for information on the amount of stress a component sees during the depaneling process. I am currently specifying a new piece of depaneling equipment and I have not found any studies that quantitatively compare the amount of stress di
Electronics Forum | Tue Jun 02 17:36:43 EDT 1998 | Chris Fontaine
| | We have experienced poor adhesion of acrylic conformal coating to plastic bodied IC�s. The observed symptoms of this are a blistering or lifting of the coating at the surface of the component, although peel testing has revealed that this is not
Electronics Forum | Tue Aug 22 11:17:04 EDT 2000 | Dr. Ning-Cheng Lee
The classic dilemma, cost vs. performance. In typical applications, Sn whisker growth is not an issue. It only seems to occur under extreme use (high stress, low temperature)conditions. Until this issue is fully addressed, Pd seems to be the favor