Electronics Forum | Tue Dec 05 10:12:51 EST 2000 | blnorman
Being in the automotive electronics industry, we use silicone (Dow 4105 is one in particular). I'll ask the same question - What are your reliability requirements?
Electronics Forum | Tue Jan 13 19:55:09 EST 2004 | Tom B
Jacob, You might want to contact Mike Moninger at (941) 359-0933 @ Thermospray. http://www.thermospray.com
Electronics Forum | Fri Oct 29 17:44:13 EDT 2004 | davidcb
Davef, thanks for inputs. I think your correct, we have since obtained some ionic analysis and sure enough there is relatively high chlorides on the bare pcbs. The toluene is controlled within dip tank / drying system, almost no exposure to workers.
Electronics Forum | Wed Mar 04 09:07:01 EST 2015 | edmaya33
Hi All; Anybody here have experience in AVR80 BA DS65 CC process? I have an issue with the curing process at 28 degC RT. Can somebody recommend how to accelarate the curing without IR oven? thanks
Electronics Forum | Tue Aug 18 21:42:48 EDT 2015 | comatose
Why not just pick up something like an old Camalot 1414 and use that? Then all the work other than rigging up a valve is already done. 1414s go for a couple or five grand in workable condition, especially without a pump.
Electronics Forum | Thu Aug 20 02:17:09 EDT 2015 | armandogomez
Is going to be a lot of work to do something like that, money and time, why not buy something on the market? camalot is a good brand or PVA is another brand.
Electronics Forum | Thu Mar 21 19:57:54 EDT 2024 | compit
I am looking for a machine to protect PCBs against moisture with varnish. It doesn't have to be very efficient, it seems that one for a desk is enough. What to look for? Is it worth looking for a used one? Best available in Europe.
Electronics Forum | Thu Sep 10 17:13:31 EDT 2015 | tombstonesmt
There are factors that manufacturers have taken into consideration when dealing with coating. On/off times, dispense speeds, heights, etc.. Dedicated software with tools to easily map out paths are a godsend. We made our own coating machine with a s
Electronics Forum | Wed Feb 23 22:38:28 EST 2005 | davef
We: * Cure 1B73 according to spec in a heat box, like a Blue-M * Clean nozzles [one set in use, one set being cleaned] in thinner in a bronson ultrasonic cleaner * Haven't evaluated coatings in years, but would do it according to J-STD-001C, Reqmnts
Electronics Forum | Thu Aug 27 10:12:07 EDT 2015 | fcmtechnician
Hi buy a manufactured machine! is not hard to build one, but the know how after you build it is the key point for you! Are you able to build and control the applicator to coat your board? are also some Budget machine on this area, look for Dima, Ca
Lewis and Clark is your #1 Pre-Owned Surface Mount and In-Circuit Test equipment supplier. We offer a variety of equipment solutions at a significant cost savings over new.
Manufacturer / Equipment Dealer / Broker / Auctions
18 Celina Ave., Unit 16
Nashua, NH USA
Phone: (603) 594-4229