Electronics Forum | Wed Dec 17 10:43:12 EST 2003 | paul_bmc
Do you have any other suggestions for Semi Auto Cut and Clinch machines. Because of Contact Systems reputation I was leaning towards them, but I had no idea they we having problems.
Electronics Forum | Thu Mar 01 14:01:04 EST 2018 | rbaker1
Thank you very much Don...!
Electronics Forum | Sun Apr 04 13:37:53 EDT 2004 | metats
Thanks for everything, it ended up being worn out brushs in the cut and clich motors. A little clean up and some elbow grease and its all ok. Thanks again, Paul
Electronics Forum | Thu Feb 11 16:33:08 EST 2010 | dougt
Contact Systems cs400e It's a semiautomatic thru hole machine that incorporates hand placement with a machine cut and clinch, was (probably still is) the benchmark in the industry.
Electronics Forum | Wed Jun 21 14:33:57 EDT 2023 | glr
You should a sequence that a D=2 Q=3 and X in going to be your bin location.
Electronics Forum | Wed Jun 28 12:04:28 EDT 2023 | nickadams
Thank you for your input. Do you know what might have caused this to happen? Just trying to prevent it from happening next time.
Electronics Forum | Tue Feb 08 10:25:46 EST 2011 | remullis
Michelle, It's been years since I worked on these machines and mine were CS400E's. The next time this error comes up instead of powering down Unplug the RS232 cable that links between the PC and the processor board in the machine, I cant remember if
Electronics Forum | Tue Apr 18 12:03:30 EDT 2023 | dskling
No. they struggle to move a little but not a full cycle. We have replaced the 3 control boards on the back door, both EMI filters, check and replaced all fuses, pulled the clinch head and swapped it with another working clinch head and that blew a c
Electronics Forum | Tue Feb 17 11:14:03 EST 2004 | remullis
Hi, I have worked with the CS400E's for 10+ years and normally when your having problems optically programming. The light bulbs are either getting dark or the filament is not positioned correctly. To set this, you will need a meter to check across
Electronics Forum | Wed Mar 10 08:08:49 EST 2004 | paul_bmc
I am having issues with a CS-400E that I thought I might ask if anyone has any suggestions. The machine may run fine for a while then out of the blue the cutters stop responding or start responding erratically, you have to hit the esc key after ever