Electronics Forum | Fri May 30 11:58:16 EDT 2008 | fredc
The right paper incorrectly applied can be a problem also. I have seen it on even new Fuji nozzles with the illumination disk bunched up on one side of the tube with a gap on the opposite side.
Electronics Forum | Fri Jul 19 11:16:21 EDT 2019 | dman97
And yes if the proper data is not correct it will give you a error message because Flexa cannot communicate with the CP6.
Electronics Forum | Fri Feb 25 16:34:53 EST 2005 | jimmyb
In your PDs you must specify a single nozzle size. Meaning don't assume that entering nozzle size max=1.3 and nozzle size min=1.3 forces the machine to use a 1.3. Nozzle size min is not used in the CP6 software (it only uses nozzle size max), there
Electronics Forum | Mon Feb 28 08:34:46 EST 2005 | Alex
Good advises thanks. I'll go thru all nozzles and vacuum check today and tell the programer about PD's and nozzle vs shutter. Should I check at the same time all the vacuum filter ? For the placement test, we use the same feeder at the same position.
Electronics Forum | Tue Jan 31 03:53:50 EST 2006 | chadnugent79
We use an alignment jig {from Fuji I believe} that checks any rotational offets from the shaft to the head. The bottom of the jig fits onto the head while the top slides around the top "what I call" the crown gear. I've had several instances where
Electronics Forum | Thu Aug 05 20:33:48 EDT 2004 | Dhanish
The machine type is Fuji CP6.We have major issues with Network Resistor placement.The equipment guys often feedback there is a problem with nozzle and feeders.What will happened to the part if the Thickness data in the Part Data does not match the Pa
Electronics Forum | Fri Jul 17 07:50:32 EDT 2009 | csm
Dear Jepoy We check the oilmatic system and I found a relay is not working, it will arrive until tomorrow. We still have 2 errors and 1 message, we are taking time because we don't have the Fuji CP6-4000 manuals or electric diagrams. we get this ma
Electronics Forum | Tue Jul 17 15:26:08 EDT 2012 | kruzer
Hi I use CP4, CP6, CP643, GLV and NXT, but i have a problem with CPIV, i cant use It with Director Fuji Flexa. i use snifer rs232 (rs232mon) to resolve problem and what i know: Computer send on rs232 to machine (every 1 min or something): vQN2105
Electronics Forum | Thu Jan 19 06:39:56 EST 2006 | dougs
It's been a few years since i worked on a CP machine but your st17 & 19 errors are probably down to grease in the clutches at the top of the shafts, if too much grease is put onto the turret gear during maintenance it tends to spray into these clutch
Electronics Forum | Mon Jul 13 09:34:32 EDT 2009 | csm
Dear all, we have an Fuji CP6-4000 we get some weeks ago, but it shows an error "Hardward NG and show some actions (Inch the axis to cancel the overtravel. Then switch the power off and restart the machine). We did but display same error. I would