Electronics Forum | Sun Apr 17 18:22:18 EDT 2022 | dekhead
Please clarify what you mean by "bouncing". Small up and down motions around home position? Full stroke of table movement up and down? Or somewhere in between? Does it start as soon as servo power is applied? Or not until table home movement is initi
Electronics Forum | Thu Nov 07 16:02:06 EST 2019 | kylehunter
OK, got a lot of information today doing some testing.. Version number:- 07 SP11 (985 B02) Released Dec 8 2006 I did the tool(less) calibration of the squeegee height, which worked fine, no error. Did a test print, as you can see from the image, t
Electronics Forum | Sun Jul 18 12:13:06 EDT 2021 | oriolsancheza
Hello, Our machine started to not stopping board into the right position (stop pin was not working we guess). After some inspection we have not seen anything strange. However the DEK software decided to not work anymore. We've been messing arrounf
Electronics Forum | Fri Aug 28 11:59:05 EDT 2015 | gascon5383
Actually I should have noted we resolved this issue. After chasing our tails for a while, we found that somehow there was a static charge on the boards going into the machine. This static was discharging to the camera through the board stop, causing
Electronics Forum | Sat Nov 09 19:35:25 EST 2019 | richardcargill
the issue is the calibration. What you set it for has to match what it actually reads or you get the error screen at the end of every pass. If you go into the maintenance menu ( using the key next to the system button ) you can check that the pressu
Electronics Forum | Sat Nov 09 21:57:00 EST 2019 | dekhead
Not to be disagreeable, but sounds like "RichC" is describing earlier series 265 calibrations... (based upon location of PSR Amp and magnets to bypass cover interlock a 265MK1 (v. 1992-94). That "readings" calibration on your mach
Electronics Forum | Sat Nov 09 19:37:52 EST 2019 | kylehunter
> the issue is the calibration. What you set it for > has to match what it actually reads or you get > the error screen at the end of every pass. If > you go into the maintenance menu ( using the key > next to the system button )