Electronics Forum | Mon Oct 05 17:07:31 EDT 2020 | dekhead
Older machine models (Horizon / Infinity) allowed you to offset the board stop (thru crative programming) to run the larger board with parameters for the smaller board. That feature is eliminated with the Micron series. However, if you can get remote
Electronics Forum | Mon Sep 22 11:26:19 EDT 2008 | mainenetservices
Does anyone out there know of anyone who can > repair the Green firewire camera (Cyberoptics) > off the Dek printers. I had 2 go bad and would > like to get them fixed if possible so I would > have backups. > > Thanks in Advance I can repair
Electronics Forum | Tue Jan 21 08:49:42 EST 2020 | emeto
I am sure you can upgrade it with DEK and it should not be so expensive. You can also ask them the price of the auto system. This is an arm(controlled by cylinder I think) and software to control it. This one moves the stencil in place when you load
Electronics Forum | Thu Aug 22 04:08:17 EDT 2002 | Jason Baldwin
Symptom: Board Stuck on Print Conveyor error messages. Cause: Board not flagging the camera sensor. Remedy: Check the following items: � Check the camera sensor can see the board underneath. � Check the camera sensor calibration (in Tools, Camera Re
Electronics Forum | Sun Oct 28 01:55:12 EDT 2012 | dman97
Hi, Does anyone have a copy of the system software for a 265 Horizon? I need the base software version 06. I have the SP update CD's but they don't help. I am getting a base system software is missing so upgrade cannot be started message when I in
Electronics Forum | Thu Jun 07 01:14:24 EDT 2018 | buckcho
Hello Diego, i will try to help you. Can you tell me which software of the DEK you use, also machine (Horizon, ela, etc)? In our machines (NEOHorizon 03ix) we can get this type of information in a few ways, but it requested by us to dek. We are using
Electronics Forum | Mon May 02 21:26:23 EDT 2022 | rob1
I have a problem with DEK 265 Horizon. During camera being homed after checking the fiducials, the camera failed to home properly and crashed into the back of the machine in the Y direction. I homed the camera in the Y and it appeared OK and I could
Electronics Forum | Wed Jan 24 15:49:32 EST 2024 | carlos_s39
Hi all, Recently the place where I work at purchased an SMT assembly line. The stencil printer is a used DEK Horizon 03i. We received no manuals with it and are having issues with the cleaner. The motor does not move and it does not move along the ra
Electronics Forum | Thu Jul 25 20:47:13 EDT 2002 | Dreamsniper
Thanks for that info... I found out that MPM has UP2000 HiE VP with price lower than DEK Horizon but just a bit higher or let's say relatively the same as DEK ELA...I find it hard to decide which among the 2 based on our budget capability. My budget
Electronics Forum | Mon Oct 03 09:19:10 EDT 2005 | John S.
We've been using Horizon 01's for a couple of years. We use the advanced 2d board and stencil to setup process control through QC-Calc. It works very well, but you must put the time into setting it up. Ask DEK if they can get you a manual for thei
