Electronics Forum | Fri May 12 13:33:27 EDT 2006 | mika
...Ehhhh?? Mark Fick, If the SMT Splice Clips or Kapton tapes does not solve Your DEK-265 motor comms failure problem, maybe try this: The 5 Volts should be within +/- 0.05 V. and if I remember correctly it must Not be under 4.5 V. We have been th
Electronics Forum | Fri Sep 26 12:16:52 EDT 2008 | bickt
you cannot swap 0-3 only 0-1 or 2-3 they are not the same euro cards. they function very diffrently. if you look you will see there are more chips and circuitry on one set. there are 2 w/red leds and 2 with green leds. at least thats how they soo
Electronics Forum | Thu Sep 25 16:23:42 EDT 2008 | aj
Hi, Have you tried to download the MINT ?if this works you should be back in business , if not,check your PSU, which you can access from the back? check the manual as to which one powers the cards- dont have manual to hand but I think it is the 5v
Electronics Forum | Fri Sep 26 08:11:15 EDT 2008 | dwelch123
Try swapping cards in Y1 enclosure. You can swap zero and one or two and three but make sure you change the shunt position and the dip switch settings and see if your problem switches cards. The lithium battery likes to fail on those cards. Reload th
Electronics Forum | Wed Dec 07 14:20:29 EST 2005 | Robert
I had a DEK 265LT with error code: motor comms failure.card 1, Axis123 fatal error-reinitialize machine during machine boost up I replaced new card 1 and still get the same error. Any suggestion would be greatly appreciated Thanks in advance, Rober
Electronics Forum | Thu Oct 04 00:07:29 EDT 2018 | gaintstar
flason smt SMT spare parts: http://www.flason-smt.com/product/SMT-spare-parts-Assembleon-Controller-Bvm-5322-216-04698.html http://www.flason-smt.com/product/SMT-spare-parts-Assembleon-Control-V2-1-Rev-B-8mm-4022-594-10010.html http://www.flason-smt
Electronics Forum | Tue Oct 11 13:35:30 EDT 2016 | mnorthey
When I had this problem on the DEK 248, the problem was the table up/down sensors on the motor. You can see if there is a problem in the maintenance mode in the inputs screen. They can be adjusted by loosening off the screws and moving the sensor un
Electronics Forum | Mon Jan 06 05:53:47 EST 2020 | richardcargill
First switch on after the holidays and this year it's the Dek265 playing up. On switch on, the screen comes up with "motor comms failure, card 0 axis123 " . On looking at the cards there seems to be a power feed missing ( see attached pict
Electronics Forum | Wed May 03 08:43:51 EDT 2006 | Mark Fick
I have a DEK 265 with error code: motor comms failure.card 0, Axis123 fatal error-reinitialize machine during machine boost up I replaced new card 0 and still get the same error.I have tried to load the mint program but I cannot get program to abort
Electronics Forum | Tue Sep 19 15:15:42 EDT 2006 | bigdaddysoy9
Have you tried changing the motor?