Electronics Forum | Mon Sep 20 14:15:32 EDT 2010 | dekhead
"System Suspended While Cover is Opened" indicates front or rear cover opened; not the head being raised. Therefore there is an issue with one of the cover interlocks not being made properly. Note there are 2 switches on each (NO and NC) one goes int
Electronics Forum | Tue Feb 22 17:03:48 EST 2000 | Chris
Dek 249 and Dek 260 models use to have fiducial recognition where table would adjust to the stencil. However, I would still recomend you buy an inline model because the change over will be much faster. Probably 10 times faster.
Electronics Forum | Tue Feb 22 17:03:48 EST 2000 | Chris
Dek 249 and Dek 260 models use to have fiducial recognition where table would adjust to the stencil. However, I would still recomend you buy an inline model because the change over will be much faster. Probably 10 times faster.
Electronics Forum | Thu Dec 13 05:30:29 EST 2012 | sunyb123
i have facing a problem in dek 265 horizon that rising table position error ,please help in for solving this problem
Electronics Forum | Thu Jul 25 23:21:40 EDT 2013 | dekhead
1000ct encoder is the only one used on DEK Horizon (Typhoon Series); 2 different manufacturers, but interchangeable. http://www.dekhead.com
Electronics Forum | Mon Jun 23 15:28:41 EDT 2014 | globalpowerproducts
I have a 1997 DEK 248 screen printer that does not have the magnetic suction cups. Any thought on where i can find these or suggestions on how to secure the board on the table?
Electronics Forum | Wed Jun 19 11:26:06 EDT 2019 | key
We have been looking at the Sol for the in and out and the up and down for the blades. We moved the sol around with no change. where is the RS cylinder located in the DEK 248.
Electronics Forum | Thu Feb 17 17:33:34 EST 2022 | mnorthey
Hi all, I have a Dek 265 Horizon that fails to print at the correct pressure. It fails pressure every pass. I am trying to Calibrate it with a PFR1200N pressure Tester which we use for our DEK 248 Printers. I am trying to build up the table height
Electronics Forum | Thu Dec 22 16:59:39 EST 2022 | goseese
My problem was the BGE9010C. Any time there was any pressure on the rising table the error would occur. I was not able to find a replacement BGE9010C so I opened it up and found some blown components. Replaced them and the problem was solved. I "
Electronics Forum | Mon Apr 18 09:52:36 EDT 2005 | pjc
FormFlex and the GridLok system will not work on a semi-automatic printer. They were designed for fully automatic machines. The print table is very shallow on the DEK 248, SMTechs and MPM SPM, UP100 and MicroFlex. DEK should have magnetic base suppor