Electronics Forum | Sat Jun 15 22:39:05 EDT 2002 | edahi
well we can't paste the flip chip on its substrate because we are using flux...because this bare die yet...and the surface of the die flipped might be contaminated...also after chip attach and reflow the die is to be underfilled and if the die is pas
Electronics Forum | Mon Mar 21 02:51:23 EST 2005 | amstech
I have done few thermocouples using high lead solder, silver epoxy that is used for die attach purposes and some X - non conductive material. Though all materials show a slight variation in temperatures (3 to 5 degree C), the dwell time at peak is qu
Electronics Forum | Mon Jan 10 11:08:39 EST 2005 | mrgman9999
We are having a problem with popcorning of a plastic BGA that has been under careful humidity control. We have had problems in the past and some have been related to too much trapped internal solvents from the die attach epoxy. We did a life time b
Electronics Forum | Mon Jan 23 21:56:50 EST 2017 | jgo
Hi all, Am new to the SMT process. I'm in the process of purchasing a new SMT Pick & Place machine and am trying to figure out how to perform the buy-off. I'm from the semiconductor packaging background. For any new machine purchase, I'm used to se
Electronics Forum | Wed Jan 19 19:47:16 EST 2005 | davef
It depends. Let's focus. The basic versions of COB are: * Semiconductor die that you place on a glued board surface, wire bond, and then encapsulate. [The crazy uncle of the COB process, accounting for 90% of the placements.] * Semiconduct die tha
Electronics Forum | Sat Jun 15 22:49:23 EDT 2002 | edahi
well as usual this for flip chip however, this application uses ceramic substrates and the nearby area in which the splatter land on is the marking area (gold pad). We cannot hide this because the package is completed bare die, meaning no heatspread
Electronics Forum | Thu Jun 09 20:48:07 EDT 2016 | deanm
I'm assuming these are two leaded axial components. GPD Global makes fluid dispensing and component prep equipment. Component leads can be formed (or bent) in order to provide some resistance in the hole during insertion. This should prevent the comp
Electronics Forum | Fri Jun 14 09:15:02 EDT 2002 | edahi
DaveF, Yeah you got that right...because the initial stages of the project, the products would only attach 1 passive (capacitor) hell when things got too cheesy they wanted to attach 20 caps or so....this is not like board assembly, this only 1 Flip
Electronics Forum | Mon Dec 28 12:16:40 EST 1998 | Jon Medernach
Chris, We are involved in several developments using gold stud bump attach. We make a stud bump bonder and have several processes for attach. Solder attach is best done by plating up the substrate, the underfill must be able to provide enough mechan
Electronics Forum | Tue Dec 29 10:24:35 EST 1998 | Earl Moon
| Chris, We are involved in several developments using gold stud bump attach. We make a stud bump bonder and have several processes for attach. Solder attach is best done by plating up the substrate, the underfill must be able to provide enough mech