Electronics Forum | Fri Jan 02 05:40:20 EST 2004 | p.LAKSHMANAN
cALIBRATION OF SOLDERING IRON DEPENDS ON THE USAGE AND AGAIN DEPENDS ON THE PERFORMANCE.NORMALLY U CAN FIX THE CALIBRATION INTERVAL AS 3 MONTHS (OR) 6 MONTHS AND ANALYSE IF THERE IS ANY SUBSTANTIAL DRIFT IN THE READINGS(BETWEEN ACTUAL AND DISPLAYED).
Electronics Forum | Fri Sep 24 14:05:06 EDT 2004 | jsloot
Is there anyone using a QUAD QSA-30? I am experiencing problems with the Y axis drifting in the positive direction. This can occur anytime from a few minutes to several hours after the problem has been fixed. Fixed means recreating a program from scr
Electronics Forum | Mon Mar 28 18:05:13 EST 2005 | darby
The Yamaha manual is pretty straight forward on this one so I presume the "Philips" is as well. Go to the Maintenance, Repair and Adjustment chapter and look up Drift-Adjusting. It is in the Controller section. If you don't have a manual let us know
Electronics Forum | Thu Jun 22 16:21:42 EDT 2006 | pms
"We certainly live in a better world now." Regarding lead-free solder I assume? If so, then............... Oh god....... Another one sucked into the EU black hole of ignorance. Sorry for the thread drift, couldn't help myself. Hope your parts do
Electronics Forum | Thu Jul 13 06:39:08 EDT 2006 | CL
Is it possible that the PCB is moving? First try an autoscan of the fids and then immediately perform a manual trim which will bring the camera over to where it found the fid. If it is on, there is an offset drift in your axis or the PCB is able to m
Electronics Forum | Thu Jul 27 05:02:11 EDT 2006 | Rob
If you don't have too many products to run, keep known defect boards for each product and run them through as a first & last off. That way you know if it has drifted out. Yes I appreciate it's not always easy to have a spare defect board/golden sam
Electronics Forum | Sat May 05 11:57:52 EDT 2007 | mohdfazuwan
i'm looking for BGA Rework Station - Temp Profiler for ERSA. Rit now i facing problem the Temp profile easy to drift from initial setting. Hope some one can advise me what type of Temp Profiler suitable for Ersa BGA Rework station. Hope the profiler
Electronics Forum | Fri May 14 02:04:16 EDT 2010 | dilogic
Sorry for not clearing that out - it's not the problem of lost vision sw. - I even can't connect to it in diag. mode. Must be some hardware issue. I've checked video outputs with the scope and instead of constant freqency ~15kHz, it drifts up and dow
Electronics Forum | Tue May 10 07:57:49 EDT 2011 | mosborne1
Are you uploading the mod codes to your central controller when you change them? If not when you run your produciton the central controller will download the mod codes that are stored in the CC. You might also have an encoder problem. When the machin
Electronics Forum | Mon Oct 06 15:17:12 EDT 2008 | davef
Q1: You say that 0.008" of "slop" is un-doable; hence, the reasons for our failures. Any basis for that statement? A1: We're not even considering the accuracy of your placement machine. We base our comments on the gap between the hole and the connec