Electronics Forum | Wed Nov 18 20:54:22 EST 2020 | grizzy
Have ekra x5 pro, 2011 vintage, need to change from german to english, any direction you can provide, much appreciated. Thank you
Electronics Forum | Mon Aug 13 03:37:18 EDT 2018 | mk15
Hello. Do anyone have a operator and main software manual and Service manual? Please send it to me. Thanks
Electronics Forum | Mon Aug 13 05:03:48 EDT 2018 | oxygensmd
Hi. As you asked me in e-mail, I sent the E4-E5 manuals. I hope that it helps to learn the new software.
Electronics Forum | Tue Aug 04 01:55:29 EDT 2020 | cbeneat
How much adjustment is needed? Adjusting the snap off will get the PCB tighter/looser to the stencil. But this is only a 3 to -3 MM adjustment.
Electronics Forum | Tue Aug 04 04:20:36 EDT 2020 | bangir
Hi Chris, It's arround +/- 2MM. There was a gap if running pcb with thickness 1MM. The PCB position below the rail table.
Electronics Forum | Tue Aug 04 13:45:03 EDT 2020 | oxygensmd
There are one value for thickness during PCB-teach function which is the PCB thickness. The other one is the camera focus in machine option but it is a dangerous function because the camera focus is adjusted by raising/lowering table.
Electronics Forum | Tue Aug 04 22:26:38 EDT 2020 | cbeneat
So 1MM is the board thickness in your program?
Electronics Forum | Wed Aug 05 06:34:33 EDT 2020 | oxygensmd
Yes if you adjust the thickness to be thin than the machine raise the PCB more to the stencil - than the foil have better tension but it string out faster.
Electronics Forum | Wed Aug 05 07:38:17 EDT 2020 | bangir
Hi Cris, Yes, The PCB thickness is 1mm. the PCB position below the rail thickness when the table go up the print position. Please advice or do you the service manual book.
Electronics Forum | Thu Aug 06 22:37:45 EDT 2020 | cbeneat
Try 2211. I honestly can't remember what this gets you into. But I used it years ago.