Electronics Forum | Mon Jan 10 03:48:15 EST 2022 | proy
Has anyone here got any innovated neat fast ways to quickly cut the end of an IC tube open clean and fast so that parts feed properly from a tube on a vibe (as best they can...) AND or any low volume easy to setup automated tube to tape and reel setu
Electronics Forum | Mon Feb 24 17:56:55 EST 2003 | MA/NY DDave
Hi Let me just give a little and someone else might chip in with fast and ready details. I don't know what your product or service is, so I am not sure how direct to the FDA you need to be for your shop. If you work for someone they should handle t
Electronics Forum | Mon Nov 05 04:59:59 EST 2001 | madreindeer
hi, I have found dull joint when I have done trial if boards and cooling too fast.Also with Nitrogen.Some of paste don�t like Nitrogen too much. Also I have seen this when profile is not hot enough or flux haven�t survived to liquidus point. I wou
Electronics Forum | Fri Oct 28 10:03:13 EDT 2005 | rlackey
They don't index fast enough - On GSM's the original "black" feeders were replaced by "blue" feeders that indexed a lot quicker, that just about kept up with a flex head. There's no way one of those is going to index 8 or 9 times a second to keep
Electronics Forum | Mon Feb 26 12:10:24 EST 2007 | JCB
As you are running Left to Right it is the trailing edge of the board leaving the board at left opto that tells the board stop to lower (not the sensor under the camera - that just confirms the board has arrived at the board stop). How big is the boa
Electronics Forum | Mon Jun 04 11:01:23 EDT 2007 | hussman
Sorry to hear that RDR. Although, I thought the statement was "drive" a Harley (not own), which I find funny. Also sorry to hear about the Vette too. Should we make it a rule that the guy with the biggest spoiler is right? Then we can make a movi
Electronics Forum | Fri Jan 07 15:04:29 EST 2011 | brianangus
Hi. I specialise in Samsung equipment and offer reconditioned systems with good warranty. I've also spent some time studying the SOny systems and have been to the SOny centre in Germany. Machines are reliable and fast but flexibility is a major down
Electronics Forum | Mon Mar 03 15:44:56 EST 2014 | emeto
with 0.5mm pitch I wouldn't go too fast. Check your separation speed as well as your print area(may be you can drive your squeegees 1-2 inches less). Some pastes like Alpha like very fast separation. so you can win another 2-3 seconds from there.What
Electronics Forum | Mon Aug 19 05:08:24 EDT 2019 | gfe
I work for more than 18 years with the assembly of electronic equipment, more than 10 years with AOI machines from Marantz, since the model M22XFV-350 which is an old-school machine, currently we work with V series, the model V22XM-350 in RGB, this r
Electronics Forum | Thu Oct 05 12:18:44 EDT 2000 | aaronho
Try the following address: FastParts.com www.xytek-equip.com www.ibe-surplus.com I think the best way is go to the original suppliers Go luck.