Electronics Forum | Thu Mar 24 22:39:22 EST 2005 | pmd
My opertaors have lots of setup problems with vib feeders. They dont realize that the chip weight pushes parts down and when feeders run low it's the frequency that drives the parts. Mixing parts with diferant phisical deminsions and masses in the sa
Electronics Forum | Thu Jan 21 02:26:30 EST 2021 | baldoino
I would like to sell used pick and place feeders for Siplace. How can I offer them (70 x 8mm; 20 x 12/16; 05 x 24mm.
Electronics Forum | Thu Jan 21 14:12:28 EST 2021 | davef
In the navbar on the left margin, select "Used SMT Equipment" In the dropdown, select "Add Equipment" Complete the description form You're on
Electronics Forum | Thu Oct 12 12:51:39 EDT 2006 | john_smith
Hey Brian how are you doing? We also have one of these feeders and it works great! The best feature is the being able to reverse the feed wheel to backfeed parts. Just talked to the guys at Hover-Davis yesterday and they have had feeders in service
Electronics Forum | Wed Apr 18 15:10:35 EDT 2012 | smtivan
Dear Colleagues! Our organization has a lot of not-intellectual feeders for Essemtec Pick&Place CSM7000, but we would like to use this feeders in Essemtec CSM7100. Does it possible? What will we need to do for normal work of CSM7100 with old feeders
Electronics Forum | Wed Jul 22 07:51:28 EDT 2020 | spoiltforchoice
> I would have thought the other way. We are > currently using 2 CP642s for high volume and they > are doing an excellent job. Electronic feeders > are too expensive and we don't see any benefit > for that expense. I imagine it
Electronics Forum | Sat Apr 11 13:09:30 EDT 2009 | jgorajia
You may want to complete some due diligence before selecting the right software vendor.....knowing after selection that you're kinda' stuck for a while. Find out support for your needs (feeder setup lists dynamically created, easy board views and po
Electronics Forum | Mon Sep 23 17:53:01 EDT 2002 | steveb
We have both Panasonic MPA3 56mm feeders and Hover-Davis 56mm feeders. You can go wider than this if you need, we also have a 72mm Hover-Davis feeder. You are correct in stating you will need to base plate for the Hover Davis feeders to work. We h
Electronics Forum | Wed Aug 02 14:54:15 EDT 2006 | chrisgriffin
I mean if you are using the same stencil for the top and bottom of a board. Thanks to everyone for the help. From what I gather, it will work when the stencil cut-outs are offset from center in the Y-axis. Doesn't work too good in the x-axis, beca
Electronics Forum | Mon Jul 31 16:33:48 EDT 2006 | G.P.
I think he meant stencils where the print pattern is front, left, or right justified on the stencil itself as opposed to being centerred. Is that what you meant. It can be done on DEK printers, but it has been several years that I worked with an MP
