Electronics Forum | Tue Dec 14 03:45:31 EST 2004 | rlackey
I don't think that the ones I encountered were "fake", I think that they were cheap copies - ie. actually meant to work, not just to part someone with their cash - engineered to a price (just a very low one!). It does seem a bit strange to go to the
Electronics Forum | Sun Feb 05 13:41:47 EST 2006 | bvdb
We recently purchased an old Fuji IP-I placement machine and have been testing 8x4 feeders for 0805 parts, etc. I have opened some of the non-working feeders to replace broken pieces and have noticed that some of the feeders are completely clean ins
Electronics Forum | Thu Sep 01 18:07:16 EDT 2005 | paulbendemire
We're looking into getting a feeder calibration jig. I know the Fuji is about $14k... Does anyone know about aftermarket? Is anyone using a jig currently for their CP643 feeders? Thanks
Electronics Forum | Tue Dec 05 12:53:21 EST 2006 | cyber_wolf
CP643'S Will run 0201's
Electronics Forum | Wed Jun 04 22:52:32 EDT 2003 | hwatali
Now we are in urgent to buy 1.FUJI CP6-4000 or CP6-5000 for 3 sets;2.FUJI CP643E for 2 sets;3.CP6 8��2 and CP6 8��4 paper feeder. If you can supply these to me,pls contact me asap.
Electronics Forum | Sun Apr 30 22:29:23 EDT 2000 | Jack
We use Fujicam for FUJI CP643 programming and optimizing in our plant. There are about 800 parts (80% chips and 20% lead components) being placeed by 2 CP643. When using Fujicam automaticly allocate feeders and optimize insert order, I got 29000 cph
Electronics Forum | Sun Apr 09 14:20:17 EDT 2006 | greatexpectations
Hi, This setup was recommended. Target is 20,000 board output per day FUJI GL-541 Glue Dispenser (USED) 32K FUJI GL 641 SCREEN PRINTER (USED) 57K CP-643E CHIP SHOOTER 255K (150 FEEDERS) FUJI QP-242E IP3 110K REFLOW 8 ZONE (IS THIS ANY GOOD) 4
Electronics Forum | Thu Jul 26 10:02:46 EDT 2018 | cyber_wolf
Load part on 0201 feeder Install .4mm nozzles in machine Load program and press start button. Feeders, nozzles and machine must be within factory specifications.
Electronics Forum | Wed Jan 05 10:22:55 EST 2005 | Mike B
We're getting an error on our CP643 that we can't seem to make sense of. It's a D1 axis error, but we're only getting it when we run a feeder on device 140. Any advice would be appreciated.
Electronics Forum | Thu Dec 27 11:07:19 EST 2007 | kpm135
Can anyone tell me the differences between the CP6-4000 and the CP643? Is the CP643 able to place a wider component range? Does the CP643 have some sort of vision system while the CP6-4000 doesn't? If anyone has the Fuji Specs on the CP643 and could