Electronics Forum | Tue Jan 30 10:43:18 EST 2007 | darburch
Before you do anything to the windmills check the heights in your PD's and if you are using board supports be certain that they are set correctly. The CP 65 has approx 1.8mm of travel before the pin will get stuck, as the nozzle should only deflect .
Electronics Forum | Wed Jan 31 11:02:19 EST 2007 | rmitchell
Hi, We think the problem was the z orgin on the X,Y, table. After calibration and adjusting the proper things are much better. Thanks to everyone. Rob
Electronics Forum | Fri Apr 23 02:15:36 EDT 2010 | smellew
Hi Rodrigo, Have you fixed your CP65? do you need some help? llew
Electronics Forum | Mon Feb 25 08:15:38 EST 2013 | cyber_wolf
Is the amp for the fiber optic working ? Even if it is changing state at the amplifier, sometimes they are not sending a signal to the I/O. That's where I would start. You can flip flop it with one of the other ones that you know are working. Make s
Electronics Forum | Mon Feb 25 08:21:29 EST 2013 | cyber_wolf
Rotate the FQ belt by hand. The amp read out should change state from 0 to 9
Electronics Forum | Mon Feb 25 22:57:31 EST 2013 | mdang
Hi Sr Tech, As you suggested, I tried with different AMP and it is display from 0 to 9 when I rotate the FRQ motor. I am going to replace the HPX-T1 AMP. Would you cut the wire or trace it to back to replace it? Thanks, -Michael
Electronics Forum | Tue Feb 26 07:37:36 EST 2013 | cyber_wolf
Save yourself a headache and splice it in. Make sure you follow the "setting" instructions that come with the new amp.
Electronics Forum | Mon Jan 20 12:12:53 EST 2014 | jimmyboz
Michael, Please post when a resolution is found. I know sometimes when looking for answers and one is found, the problem is gone, but try to close it for the benefit of this forum. Thanks,
Electronics Forum | Fri Mar 02 18:44:43 EST 2018 | magergar
At boot there is an alarm that I can't get rid off Servo Alarm FRQ AXIS Servo Overflow I tried to calibrate it in mecha mode but the same error doesn't let me, it's there something I can do?
Electronics Forum | Wed Mar 07 19:07:36 EST 2018 | magergar
I have changed the FRQ Amplifier with the FQ amp that has the same parameters and the error persist, the Zero Setting Sensor and the Clutch Origin sensor are working too. Any other posibility?