Electronics Forum | Sat Oct 10 09:01:46 EDT 1998 | Al Carrillo
| we currently have a siplace line(80s/f) and are inhereting a fuji line from another site. I need an objective comparison between the two. What are the strengths and weaknesses of the fuji with regard to programming, operating and maintenance. any c
Electronics Forum | Mon Jun 19 10:10:18 EDT 2006 | rmitchell
Hi, Our CP6-5 has a Z overflow error when trying to zero set. The table moves in X and Y and almost zeros prior to the Z overflow. Servo Amp? Rob
Electronics Forum | Wed Oct 27 10:22:15 EDT 1999 | a.blair
Fuji is usually the cheapest you will find. I think around $750 for them to repair it. the last time I checked they have an exclusive patent on their PCB backplane design so there would not be any real way to bench test it. they also have rights to t
Electronics Forum | Thu Oct 28 20:14:28 EDT 1999 | xujun
hi,sai: we have a same m/c that is cp-43,but we haven't encounter the problem about servo board.I think is ac- speed- adjustment servo board.if you can conform th board is bad,consulting the fuji service agent is the best way! best regards
Electronics Forum | Mon Oct 25 22:27:53 EDT 1999 | SaiWong
I have two of the servo boards of the Fuji CP4-2 SMD3 version are mulfunctionaled. I don't know if it can be fixed or not. May be the moisture killed the board. A new one costs about USD 5,000 each. I wonder if anyone knows who or which company can
Electronics Forum | Wed Jun 21 09:23:28 EDT 2006 | rmitchell
problem solved. Some PCB table support pins were jammed down in the table preventing the Z axis from lowering all the way. The intial error mesage was x and y servo, but the real error was the z axis overflow. Rob
Electronics Forum | Wed Jun 21 04:11:31 EDT 2006 | daxman
Are you familar with using the mecca mode on Fuji machines? There is a procedure I can take you through that will check the servo amp and allow you to adjust it. Is your machine useable at all? can you get it to pass zero set? If you can, view your s
Electronics Forum | Sun Jul 09 03:05:14 EDT 2000 | Ben
Hi Hermie, Did you perform a Servo-zero-adjustment and Gain calibration on the amplifier after replaced it ? This is necessary fine turning when replacing the amplifier. You had better ask Fuji service center for the procedure. Hope this help you.
Electronics Forum | Wed Oct 29 20:58:31 EDT 2008 | rmitchell
Hi, Our Fuji CP6 table is rising up abruptly when it unloads a pcb after populating it. It makes a clunking noise much louder than before. I don't see anything that has changed or gets in the way as far as the table rails lining up with the exit c
Electronics Forum | Wed Jun 04 22:52:32 EDT 2003 | hwatali
Now we are in urgent to buy 1.FUJI CP6-4000 or CP6-5000 for 3 sets;2.FUJI CP643E for 2 sets;3.CP6 8��2 and CP6 8��4 paper feeder. If you can supply these to me,pls contact me asap.
.gif)
