Electronics Forum | Thu Jan 20 07:49:06 EST 2011 | cyber_wolf
klaatu barada nikto
Electronics Forum | Wed Jul 11 12:49:49 EDT 2012 | cyber_wolf
There is probably a component stuck in the theta gears or it needs PM'ed
Electronics Forum | Wed Apr 15 11:03:59 EDT 1998 | Haim Halpert
We are looking for some basic mechanical parts to advance parts in the Tape & Reel Carrier Tape using a stepmotor. The Carrier Tape we use is as per the EIA Standards and I imagine there are dozens of companies that make a sprocket gear to handle t
Electronics Forum | Thu Mar 03 09:58:59 EST 2005 | Marc
The gears should be wet. This gear box acts like a rear end axle. Not sure of the lubricant but it is like a red transission lube, comes in as complete unit from supplier. You can't get the lube from Speedline since it is sold as a complete unit.
Electronics Forum | Fri Aug 12 08:33:07 EDT 2005 | Rob
Just came across Dektec reflow ovens in the Equipment Mart section - at apparently very low prices. Has anyone seen or used this gear? Is it too good to be true? Or is it another example of what volume low cost manufacturing can do? Looking at wha
Electronics Forum | Tue Sep 12 01:54:57 EDT 2006 | AR
I assume that you are referring to the same kind of mechanical feeders (older type) that are used on the Philips (Assembl�on) Topaz as well. First make sure that the right gear pulley spring is set to its stiffest position (the loop at the end of the
Electronics Forum | Fri Nov 18 16:26:17 EST 2011 | olddog
Hi again Bob, I checked the theta motor coupling and the set screws are definately tight. I noticed that the theta motor drives an snti-backlash gear (nice design) so there is no play there. It appears that the gear drives a slotted shaft which is d
Electronics Forum | Thu Feb 15 07:04:59 EST 2001 | CRAIGS
Antonio, one possibility I have seen before on BGA shorts was due to chain slippage on the reflow oven due to worn gearing, the slippage was not severe enough to move other SMT devices but was enough to disturb the molten solder under the BGA
Electronics Forum | Wed Apr 15 12:02:02 EDT 1998 | Jim Hoxie
| We are looking for some basic mechanical parts to | advance parts in the Tape & Reel Carrier Tape using | a stepmotor. The Carrier Tape we use is as per the | EIA Standards and I imagine there are dozens of | companies that make a sprocket gear t
Electronics Forum | Wed Apr 15 12:01:27 EDT 1998 | Jim Hoxie
| We are looking for some basic mechanical parts to | advance parts in the Tape & Reel Carrier Tape using | a stepmotor. The Carrier Tape we use is as per the | EIA Standards and I imagine there are dozens of | companies that make a sprocket gear t