Electronics Forum | Thu Mar 09 20:48:30 EST 2000 | Dave F
Van Hoang: Welcome to SMTnet!!!! Regarding your problems: 1. Cleaning glue: Check the SMTnet archives. For instance, a recent thread was: cleaning glue off of stencils - pr 13:41:43 03/03/2000 2. Bridging on the wave: Bridging on the wave h
Electronics Forum | Thu Jun 29 09:12:27 EDT 2000 | sree
What is the best aperture opening for micrBGA with 0.8 mm ball pitch and 16 mils ball diameter?The pad size on the PCB is 12 mils.
Electronics Forum | Wed Feb 16 09:30:11 EST 2000 | MARK ALDER
Please refer to the archives on SMTNET date 02/19/1999 on aperture sizes for printing SMD adhesives. Regards Mark Alder
Electronics Forum | Fri May 26 05:54:40 EDT 2000 | Sal
For the past year now we have been printing adhesive with no real problems. Our printing ranges from 0603's to SOIC using a variation of aperture sizes and metal thickness foils. The crucial parameters are : aperture sizes : These obviously depend o
Electronics Forum | Fri Jan 17 15:36:23 EST 2003 | davef
How do 0.5 mm pads on the board help paste release from the stencil? Paste release from the stencil is a function of: * Paste * Printer operation * Stencil design You have no obligation to made your stencil apertures the same size as the pads on yo
Electronics Forum | Thu Jun 29 11:52:23 EDT 2000 | JAX
sree, There is no Definite. You have to make the call. If you think the previous info was on target, use the info provided to find out the appropriate percentage relation between ball diameter, pad diameter, and aperture size. If you already run BGA,
Electronics Forum | Tue Aug 04 11:10:22 EDT 1998 | Chrys
| Hi Stoney, | Justin is giving you some good advice, unfortunately these kinda' problems sometimes call for the ol' D.O.E...otherwise, you could be chasing your tail for a while until you figure out exactly what's causing your problems. | Has
Electronics Forum | Thu Jun 29 09:46:41 EDT 2000 | sree
Hi Jax, The microbga discussed earlier in the forum is mounted on 16 mils pad whereas mine is on 12 mils pad. Can I use the same aperture opening ?Please advise.
Electronics Forum | Thu Jun 29 09:29:46 EDT 2000 | JAX
sree, You might want to check the archives. If not, I found this just a few questions below yours!! [Back to thread listing at top] Posted by Igmar on June 22, 2000 at 10:27:26 AM EST Can someone please help with the aperture size on a Micro BGA st
Electronics Forum | Mon Jun 07 14:16:20 EDT 2004 | Rob
I've been approached by my design engineer who would like to know what is the largest component I can place on the secondary side of a double-sided PCB (without adhesive or glue) and not have it fall off when I run the top side. Currently, I can plac