Electronics Forum | Mon Sep 20 13:05:05 EDT 2010 | dman97
Hi, Yes I tried to do that. When I stick a key inside the slot, I still get a system suspended error. Although I can press the system switch and I can hear the locks engage, but nothing happens. the machine still thinks the covers are opened and
Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Wed Jun 17 01:02:16 EDT 2015 | armandogomez
Hello Had a similar problem way back with the hydra, first go to the service program manually activate the hydra camera then move the Xwagon to place the hydra ref plate over the hydra camera and check first if the camera works, second the image you
Electronics Forum | Tue Mar 28 19:43:49 EDT 2017 | aemery
Simon, Trying to dust off my 400 knowledge here, I can picture the 500 and 1500 better in my head. I think the 400 also has a Z axis amplifier box in the back of the machine. Remove the rear lower door and pull out the big square vacuum box. If it
Electronics Forum | Fri Mar 06 07:15:38 EST 2015 | saoasasd
Hi, I have faced some problems with DQFN PACKAGE 132 PIN. After some cross sections and dye pry analysis we could find a head on pillow situation always on inner row pads. The PCBAs are double side and the DQFNs are assembled on Bottom side (Noteboo
Electronics Forum | Thu May 03 22:51:14 EDT 2007 | jmelson
I am still learning the CSM84, but have gotten one board programmed and working. Now, I'm doing the next board, and need to use the mechanical alignment unit for a 22 x 22 mm TQFP. This chip is too large to clear the jaws on any head. Can the CSM h
Electronics Forum | Tue Nov 01 20:40:03 EDT 2011 | mikeincal
What may be happening is an early trigger of your vacuum sensors during production due to a clogged tip or vacuum line in the head. What happens during production is that the Y axis gets into position, and then the vacuum sensor input is monitored on
Electronics Forum | Thu Jun 12 08:57:32 EDT 2014 | sargeredarmy01
Hello Everyone, I will try to keep this short and sweet while explaining the best I can. I have a Fuji IP-II that I have been working on trying to correct some issues that the previous operator caused. Over the last month or so I have been working
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
Electronics Forum | Tue Aug 17 10:41:13 EDT 1999 | Steve A
Wayne, Sounds like a gasketing problem. When the horizontal apertures are bleeding but not the vertical apertures. Could be poor underside support, HASL miniscus issues, masking or plugging issues, but what many people do not account for is that t