Electronics Forum | Mon Apr 26 22:25:04 EDT 1999 | Big K
75) but the right thing is to change the light source in the robot that is rejecting PLCC's..it worked for us!!! | | Larry, | | | | I have seen this problem on our machine with PLCC 28's, same part same PD, same program except head 2 would place hea
Electronics Forum | Tue Jun 26 20:40:36 EDT 2001 | davef
Your profile seems reasonable, as you say. As CPI says: Sure it could be planiarity issues with the balls, but that is not something that makes me want to do a Pete Rose belly-flop, head-first slide into first base that this is the source of your p
Electronics Forum | Mon Apr 26 22:53:30 EDT 1999 | Dean
| Recently, we have been having problems with PLCC's passing vision on our IP's If the part is set up to be placed on Head 2, it will not always pass vision. However, if we move it over to Head 1, it will pass and place just fine. Now, I do realiz
Electronics Forum | Fri Dec 07 15:23:27 EST 2001 | davef
I'm with Brian. TIN COATED 0603 FAILURES Welcome to the lead-free generation. ;-) The Eurolanders are so blanking stupid, it just makes my head hurt. But then again, it doesn�t take much. OK, enough pontification. Your profile is setup incorrec
Electronics Forum | Sat Apr 28 10:56:25 EDT 2007 | basem
Hello Everyone, Since only today I found out that MYDATA is made in Sweden and not in the U.S. and since I do not have much time on hand to figure all things about these machines. I would like your help on the following MYDATA related questions: 1)
Electronics Forum | Fri Jun 19 15:03:15 EDT 2020 | jmelson
OK, I am really happy with the robustness of my CSM84. I wonder how hard it would be to hack up one of these 3-phase machines to run off single-phase power? Mostly, it just feeds a big DC supply for the X-Y servos. 2 heads with ANE should be just FI
Electronics Forum | Mon Apr 01 12:07:25 EST 2002 | slthomas
* What material are you using? Loctite 3609 * What is your cure profile? In excess of the 90-120 seconds at 150C that Loctite recommends. * Dot dimensions and tip? 27g. conical tipped needle for the 0603's. I started with a 14 mil dot which loo
Electronics Forum | Wed Apr 20 10:16:21 EDT 2016 | ttheis
Yeah, I think it has to do with both changers being owned by the one head. If each changer was owned by separate heads then they would each need an open hole.
Electronics Forum | Sat Mar 30 17:27:45 EST 2002 | davef
You should not have glue "all over the place." Tou should not have glue on solderable surfaces. It sounds like you are stringing glue from one dispense location to the next. Search the fine SMTnet Archives [there might be something there]. Read a
Electronics Forum | Mon Apr 01 20:10:24 EST 2002 | davef
Oh. [Howabout if I smack you?] If ahma connectin� wif whut yer sayin�, you: * Don�t like the appearance of the glue slobberin� out from under the component even though there is no apparent glue on solderable surfaces. * Concerned about the hydrosco
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411