Electronics Forum | Wed May 19 17:43:25 EDT 2010 | pforister
Hello, I'm having problems with voiding on an assembly that has a GPS hybrid with balls much like a BGA. This is a RoHS assembly using no-clean solder (Kester EM907). The voids are at or above 25%. I use an 8 zone oven where I peak in zone 7 and
Electronics Forum | Thu Apr 20 22:46:26 EDT 2006 | samir
Amol, I thought I answered your question in another thread, dude! Anyway, to re-iterate. Yes, I was able to pull it off a hybrid profile. The LF BGA passed tensile testing, but no, it wasn't thermally cycled or stressed first to expose any latent
Electronics Forum | Wed Jun 21 11:09:37 EDT 2006 | samir
Muse, I agree. There has been much debate but the previous scenarios discussed in the forum have been regarding the SAC/RoHS BGA and Sn-Pb paste. I have successfully collapsed a SAC BGA with a Sn-Pb paste using the "hybrid" profile that Amol refers
Electronics Forum | Mon Jan 17 17:38:29 EST 2011 | bandjwet
All: I am reaching out to get some suggestions on the right flux to use as well as a recommended cleaning process for soldering a KOVAR RF shield using 80/20 Au/Sn solder to a ceramic hybrid. The recommended profile is 4-5 min at 280C and at least
Electronics Forum | Tue May 01 07:38:11 EDT 2007 | realchunks
You say the BGA recommended profile? Or did you mean the solder paste recommended profile? I would use the solder paste profile over a parts recommended profile any day. You may need to create a hybrid of the two to get better results. What type
Electronics Forum | Wed Aug 15 19:55:46 EDT 2012 | hegemon
If you are doing X-Ray post place and pre-reflow you should be good. Look elsewhere. Check profile - full lead free or hybrid? Be sure you are acheiving the required reflow temps and TAL required for the solder paste too. Check for belt movement
Electronics Forum | Wed May 24 16:01:08 EDT 2006 | samir
GEB, Datasheets are usually just guidelines and most App. Engineers from paste companies will tell you that as well. You don't have to "copy exact" what they say, but rather set your oven to what gets you and your type of boards the best results. P
Electronics Forum | Fri Jun 15 22:00:23 EDT 2007 | grantp
Hi, Thanks for the reply guys, and this is interesting information. I had assumed that if we had a paste spec, and this was the spec for the solder to reflow correctly, then if I achieved that spec, the solder should perform correctly. However this
Electronics Forum | Thu Aug 13 07:53:40 EDT 1998 | Earl Moon
| | Couple of questions. | | 1) Are we talking alumina substrates as the ceramic material? | | 2) Are we co-firing gold as the conductors on the substrate surface? | | 3) In other words, is this a hybrid thick film circuit? | | 4) If so, how large or
Electronics Forum | Wed Apr 21 22:15:12 EDT 1999 | Chris
| I'm having problems with trying to get a good solder joint using a Ceramic PCB. We are using AMTECH hi-temp solder (ws-486 96.5/3.5ag). My profile looks great and I used the recommended profile from Amtech with a few adjustments. My max temp is abo
