380 ip3 results

Electronics Forum: ip3 (Page 4 of 38)

IP3 machine

Electronics Forum | Sat Aug 19 03:05:49 EDT 2006 | jorge maldonado

hello, I have a problem with one ip3, some of you knows if the speed of the MTU can be manipulated and how? thanks Jorge Maldonado

Fuji IP3 Problem

Electronics Forum | Wed Aug 23 12:04:32 EDT 2006 | fastek

I am going to be scrapping out a 1997 IP-3E soon. It is a complete machine EXCEPT for the 4800 vision card. If there are cards you might need and don't feel like getting hosed by Fuji, let me know. Rick

Fuji IP3 Head squealing

Electronics Forum | Wed Dec 20 07:08:51 EST 2006 | cyber_wolf

We have had this happen. The Z-ball screws do go bad in IP3's. We replaced the ball screw and the problem went away. As mentioned improper belt tension will cause the servo to make loud noises. But if you say the movement is rough, then the ball scr

IP3 motion video

Electronics Forum | Thu Mar 15 12:59:20 EDT 2007 | jdengler

Mark, We have an IP3 that I can videotape for you when we get all the components in for our next job (probably around 3/21/07). The only thing that will be missing is the tray feeder operation, as this job does not use any components from a tray.

IP 3 board support height

Electronics Forum | Tue Apr 08 12:16:58 EDT 2008 | pstone

I have four IP3�s all that require different height board support pins. Is there a way to adjust the table height so all of the machines are the same?

IP3 parts camera

Electronics Forum | Mon Apr 28 09:34:21 EDT 2008 | cyber_wolf

Does anyone have a source to get IP3 parts cameras fixed ? Camera type is FH2048BNA

IP3 placement for BGA / MicroBGA

Electronics Forum | Tue Mar 17 11:06:33 EDT 2009 | cyber_wolf

We have never been able to get our IP3 to place BGA's consistently. We installed new bulbs,ran glass plate calibration,played with scan speeds, scan area etc. etc.... I would not recommend this machine for BGA's

FUJI IP3

Electronics Forum | Thu Oct 04 10:00:57 EDT 2012 | jimmyboz

The IP3 AND the MTU4 each have a proper. From the main menu "editor-proper" and type "new" it will then ask which machine. After that, you should be good to go.