Electronics Forum | Sat Oct 30 16:53:19 EDT 1999 | jason
David I have recently taken the IPC-A-610B instructors course and according to the teacher the revised addtion is suppose to be 50 percent fill in plated thru holes
Electronics Forum | Wed Feb 24 07:56:53 EST 1999 | Brian C
Under IPC-A-610 Section 10.3(Components on their sides) it reads: ______________________________________________________ Acceptable - Class 1,2 Nonconforming Defect � Class 3 Chip components on its side provided the following are met: Chip
Electronics Forum | Wed Feb 24 10:56:12 EST 1999 | Steve Schrader
| Under IPC-A-610 Section 10.3(Components on their sides) it reads: | ______________________________________________________ | Acceptable - Class 1,2 | Nonconforming Defect � Class 3 | | Chip components on its side provided the following | are
Electronics Forum | Thu Dec 17 16:42:26 EST 1998 | Dave Clements
Has any anyone established / published quality standards for BGA solder joints? Is IPC-A-610 in process of adding standards for BGAs?
Electronics Forum | Wed Dec 19 09:23:47 EST 2001 | davef
Bow & twist for bare boards and panels: IPC-A-610 1.5% for PTH only and 0.75% for SMT
Electronics Forum | Tue Mar 26 23:26:35 EST 2002 | ianchan
Hi Guys, (Note: We are not talking about bill-board RES/CAP, we are talking about Z-axis slant/tilted RES/CAP with respect to the PCB pad Z-axis plane). 1) We ref through the IPC-A-610C specification "bible", and can not find a "chapter/verse" tha
Electronics Forum | Wed Jan 15 23:32:36 EST 2003 | tinson
How about section 12.2.12 of IPC-A-610C? It doesn't include detailed description of root cause/effect but acceptance criteria.
Electronics Forum | Thu Jan 30 12:16:43 EST 2003 | Steve
Can anyone tell me what parts on the pwb should be protected by the conformal coating, and what parts can be free of the coating (such as the areas without components, traces, brides lands)? we were follow MIL standard 2000 and IPC-A-610 class 3. Tha
Electronics Forum | Tue May 27 17:09:46 EDT 2003 | davef
J-STD-001C, Table 11-1 is a good starting point.
Electronics Forum | Mon Feb 02 16:42:03 EST 2004 | davef
Bow & twist for bare boards and panels: IPC-A-610 1.5% for PTH only and 0.75% for SMT. So, what are you doing to these poor boards to make them warp?
