Electronics Forum | Tue Jul 06 13:02:41 EDT 1999 | John Thorup
| | I've heard that use of VOC free flux with wavesolder fixtures can be challenging due to entrapment of water in the fixture. | | | | Is anyone out there successfully running VOC free with wave fixtures & did you experience problems? If so, how d
Electronics Forum | Mon Jul 05 18:45:01 EDT 1999 | JohnW
| Is the no clean solder paste as good? We are wondering if we can elliminate the wash when we change from through hole to surface mount. | John, No clean is as good as your process, and the paste you are using. Everything I do is no clean and I h
Electronics Forum | Wed Oct 25 10:38:49 EDT 2000 | JohnW
Adam, Ha yes the joy that is wave soldering, and don't we love customers that forget the simple little things like putting connectors in the right way! It's a common thing and one way to get round it is to angle the cards towards the wave, typicaly
Electronics Forum | Wed Aug 01 11:11:38 EDT 2001 | JohnW
hi Folk's, Ok so I'm looking for some thoughts on Conductive Epoxy's. I'm trying to replace a material that i can place between a QFP and the PCB to transfer heat from the component to the PCB. The material has to be able to be injected thro' a hole
Electronics Forum | Sun Oct 10 17:57:48 EDT 1999 | JohnW
Folk's, I'm just tying up some loose end's on my Master's Thesis on solderballing @ wave soldering and the effect the topography of the mask / PCB has on it. I was wanting to do a straw poll on you guy's as to the type of resist's you are using Glos
Electronics Forum | Fri Sep 24 14:46:09 EDT 1999 | JohnW
| | I need to put together some quickie training material | | for our customer service people. I've only got about 30 minutes | | to describe the SMT process in a nutshell, so it can't be lengthy and detailed. A ppt file would be best. | | Is there a
Electronics Forum | Fri Sep 24 14:47:11 EDT 1999 | JohnW
| | | I need to put together some quickie training material | | | for our customer service people. I've only got about 30 minutes | | | to describe the SMT process in a nutshell, so it can't be lengthy and detailed. A ppt file would be best. | | | Is
Electronics Forum | Tue Aug 10 11:12:27 EDT 1999 | Steve_S
| Folk's, | | I'm looking for some helpful suggestions for reworking wave soldered bottomside components that have been glued. | I'm not a fan of the twist and break approach and as some of them either have a double dot or a slot configuration this
Electronics Forum | Mon Jun 14 09:33:54 EDT 1999 | Adam Pratt
| In past PCB designs I have cleared all traces from all layers | (except pwr/gnd) from fiducial area. It has come to my attention that this is only necessary on the side where fud is placed. Which is the correct method of design using a fidicial?
Electronics Forum | Mon Jan 21 09:27:02 EST 2002 | JohnW
Here's a question for you to mull over. I've got a PCB that is 4 millimeters thick, that's about 160thou of USA money if you like it that way. The question is IPC reg's for hole fill say it should be a min of 75% hole fill and 50% on ground planes. A