Electronics Forum | Thu Nov 30 16:31:40 EST 2006 | techgonecrazy
This has been a problem from the start. I used a digital flowmeter to check exhaust and both sides are pretty even, however, I do not know if its exhausting too much or not enough, just going on the PE specs...but then again...do they really know. I
Electronics Forum | Fri Dec 08 21:23:16 EST 2006 | Harsha
I am seeing a problem of flux droping on the PCBA during reflow. This is a pb free process and I am using KOKI pb free paste with 8 zone (and some 9 zone) reflow ovens. Line throughput is about 10,000 boards/24 hours. I suspect that the exhaust is no
Electronics Forum | Wed Dec 05 11:04:06 EST 2012 | emeto
AIM can give a good result, I tried the solder > paste from many manufacturer - AIM, Kester, > Indium, Koki, Alpha Metals, Heraeus - but I > stopped my choice at Kester. For example, right > now I have EM907 with date of manufacture in > februar
Electronics Forum | Tue Mar 25 02:58:24 EDT 2014 | molder
ok.. thanks you so much.. I will buy new dispenser siringe, and I try to rework... I have a questions on desolder and solder a socket 1366 intel on motherboard. I have a rework station Honton hot air and tornado infrared, but i don't know a temperatu
Electronics Forum | Mon Mar 16 13:35:20 EDT 2015 | swiese242
This has been a challenge for most manufacturers. It depends on board thickness, lead or lead free paste/parts. We have a slim-kic to get the profiles correct in our 14 zone oven. I believe it may be the recently posted suggestion of too much heat in
Electronics Forum | Thu Sep 01 12:07:35 EDT 2016 | pavel_murtishev
Is there any field proven spray cleaning technique able to remove flux residues under OSRAM LEDs? Is it possible in principle? The problem is that OSRAM LEDs are low standoff ones and I absolutely have no idea how cleaning agent could get there. Mo
Electronics Forum | Thu Jul 26 04:26:59 EDT 2018 | Robl
Hi VChauhan, I'll preface this by saying I am no DaveF. Voiding can occur when the flux in the paste boils and vapourises, the expanding vapour needing somewhere to go displaces the paste. So... what we have done in the past: 1) Step the stencil d
Electronics Forum | Fri Aug 24 01:25:58 EDT 2018 | cupet
Hi everybody, please advise in case of soldering problems after the reflow soldering. The problem occurs randomly at different locations on different PCB's (not the complete surface of the board). These places are very difficult for rework. Could you
Electronics Forum | Fri Feb 28 14:53:08 EST 2020 | rlising
Hi, I purchase a leadfree aven solder pot 300w. We are wanting to pre tin power and ground wires prior to soldering onto pcb. I have some anti-erosion flux cored wire solder from koki S03x7Ca-70m 1.6mm. Can this solder be used? If not what is t
Electronics Forum | Sun Jun 04 13:53:08 EDT 2023 | kumarb
We own the Ekra X4 and pleased with it. Solid phone support from factory in the US. Do review GKG out of Asia which is supposed to be $20-$30k usd https://www.gkgasia.com/smt-printer-g-titan/ In speaking with Koki, they have the new Yamaha SMT pri
