Electronics Forum | Tue Oct 24 11:26:03 EDT 2006 | geb
Hi, I've had some trouble with one of my GSM cameras. Its a 1 mil camera (in circular housing). Some components have fallen down the gap between the glass cover and the LED array closest to the rails. One of the resistors (closest to the left) has b
Electronics Forum | Tue May 28 12:56:22 EDT 2019 | dekhead
It is a communications failure between the CPU and the Cognex card. Does comms initiate between the 2 cards (flashing green on both)? or does it immediately come up red LED on Cognex? Have you reseated the CPU board as well as the Cognex? Is this a s
Electronics Forum | Sun Aug 28 23:53:58 EDT 2016 | aemery
I don't think there is a camera off message in the software, but I might be wrong. So I am making a bit of an assumption here that you didn't have a displayed image and your error was a fiducial not found error. I am also wondering if you decided to
Electronics Forum | Fri Dec 05 08:30:55 EST 2003 | pjc
If your operation is hi-mix low-volume, consider taking a look at some of the bench-top units out there. They are lower cost but can give similar performance as higher cost in-line systems. Some of the bench-tops cannot do solder fillet inspections t
Electronics Forum | Wed Dec 10 15:45:02 EST 2003 | Carl
If your operation is hi-mix low-volume, consider > taking a look at some of the bench-top units out > there. They are lower cost but can give similar > performance as higher cost in-line systems. Some > of the bench-tops cannot do solder fillet
Electronics Forum | Thu Jan 13 17:45:24 EST 2005 | vickt
Clark, As a start....Do you have a qualified tech on site to verify that the camera lighting is within spec? If not it's hard to say where you are starting from. I know that UIC still has trained personel that can help you out on this older gear if y
Electronics Forum | Tue Aug 02 10:46:03 EDT 2016 | proceng1
We are getting more and more customers wanting LED boards built on White Solder Mask. Well our printers do not get as much contrast between the white mask and the plated fiducial pad, and often the camera only sees white. Other than playing with
Electronics Forum | Fri Nov 03 11:36:34 EST 2006 | mika
Hi, It is good news to "hear" that You found the problem. This control board has also broken for us once but we had a broken camera unit from where we took this board as a replacement. Unfortunately I was not able to find the circuit diagram (among a
Electronics Forum | Tue Aug 31 10:48:36 EDT 2004 | mriddle
Rob and JohnR The ASC/Samsung VSS Series AOI uses white LEDS and high-speed, high-resolution digital color cameras for image acquistion. While it can inspect for correct color by comparing RGB or HSL values, it does solder inspection by acquiring a
Electronics Forum | Fri Oct 27 12:54:04 EDT 2006 | mika
Hi, This a common problem with the GSM P2P cameras, once in a while chip gets between the "protecting?" glass and the led-cards surronding it. It has happen to us several times (we have 2.6 & 4 mil/pixel cameras ring lighting, but it is the same lig
