Electronics Forum | Tue Jul 05 10:27:34 EDT 2005 | GEB
The nozzles are brand new too (got them friday). 08MPF (0.08") is their part number. I tried using the air kiss feature in the setup mode and found that it blew the nozzle off the nozzle holder, not sure if this is ment to happen in this mode, but t
Electronics Forum | Wed Jun 21 04:11:31 EDT 2006 | daxman
Are you familar with using the mecca mode on Fuji machines? There is a procedure I can take you through that will check the servo amp and allow you to adjust it. Is your machine useable at all? can you get it to pass zero set? If you can, view your s
Electronics Forum | Sat Sep 08 23:36:14 EDT 2012 | mtech88
Can anyone help me out this Fuji CP4 problem? I just move my machine to a new place, The feeding sensor error keep on poping up. but the mahine work on manual mode. When we switch to auto mode, it just to pick up the part and the machine stop on t
Electronics Forum | Mon Sep 10 12:18:05 EDT 2012 | benreben
Hi, what's the feeding sensor error? the sensor for cartrige or the sensor on cylinder up of feeder? manual is step mode? if you have the number of error at screen,i have the fuji error code help. in step mode the machine is very slowly,maybe the a
Electronics Forum | Mon Jul 08 17:07:15 EDT 2013 | wsdauchy
We have 2 CS9100 Schleuniger wire cut/strip machines. They do not have the DISPLAY/PC switch on the back of the CPU card. THe two machines come up PC mode. Any one know of a jumper setting on the CPU board that will allow the machnies to run in DI
Electronics Forum | Sun Nov 10 05:40:27 EST 2019 | compit
It turned out that only SF heads support "fine" mode, while FNC does not. Probably because above the FNC nozzle there is a "circle" rotating the nozzles, and in fine mode it can interfere with the reflection of the camera light - the element is lower
Electronics Forum | Thu Feb 10 12:47:47 EST 2022 | bukas
1. disable driver update (system and regkeys) 2. reboot in safe mode 3. disconnect internet 4. uninstall any nvidia driver using IO Bit uninstaller 5. uninstall nvidia and intel drivers using DDU 6. reboot in normal mode 7. install intel driver from
Electronics Forum | Mon Nov 10 23:20:55 EST 2008 | stanyserrao
Light Units are replaced with new if the problem > of lights then it will not vision process the > nozzle center measrement and resolution Jigs > too.. > > Jig is meauring in trace mode and > identifiying all leads which are fine > fitch. > >
Electronics Forum | Fri Apr 19 15:49:56 EDT 2002 | davef
While our group is not involved in product FMEA, periodically we get dragged, kicking and screaming, into a FMEA for: * Quoting the assembly or test of products. * Evaluating the potential purchase of process equipment. * Assessing the potential impa
Electronics Forum | Tue Apr 03 20:46:32 EDT 2007 | Mike Konrad
We manufacture similar equipment. I would recommend that most of the testing be performed in an automatic shut-off mode. There are potential issues with both methods, automatic shut-off and fixed time tests. In an automatic shut-off mode, the cl
