Electronics Forum | Thu Feb 04 04:16:56 EST 1999 | Joni Siipola
I'm researching SO-8 power RF device mounting methods. Possible mounting method 1. Via thru holes Still the thermal resistance of the PCB too high Do you have suggestions for mounting the component, PCB/?
Electronics Forum | Tue Sep 01 14:11:27 EDT 1998 | Matt
How would you mount a surface mount chip onto Perf board? I am doing a project for school and one of the chips is a surface mount, but everything else fits in Perf board. Any suggestions? Thanks
Electronics Forum | Tue Jan 08 14:51:11 EST 2002 | edmentzer
The only time we had this problem was when the operator let the mount tool test position on the board be a mounting hole so the machine did not know where the board top was. You might want to check the mount tool position as a lot of PCB CAD people
Electronics Forum | Mon Jun 05 14:09:30 EDT 2000 | RFM
Hi everybody, could someone tell me what does it mean the term "Straddle Mount"
Electronics Forum | Thu Feb 04 20:31:10 EST 1999 | Dave F
| I'm researching SO-8 power RF device mounting methods. | | Possible mounting method | | 1. Via thru holes | | Still the thermal resistance of the PCB too high | | Do you have suggestions for mounting the component, PCB/? | Joni: What is it ab
Electronics Forum | Thu Jan 20 19:45:20 EST 2005 | yohelyav
We are looking for news on new or used Surface Mount Machines to buy, rent or lease. We want an assembly circuit board machine: Making circuit boards Important: * must have and be able to run surface mount machines. * load reels
Electronics Forum | Thu Aug 21 19:18:47 EDT 2008 | duchoang
My steps are different in that case: 1- Check mounts. Try to adjust origin point until get the pretty good mount positions. 2- Teach fiducials ( Board fids, not panel fids) 3- Use fids, check mount again. 4- If OK, then teach Block Repeat. This alwas
Electronics Forum | Mon Nov 10 19:34:20 EST 2008 | snsmt
Hello all, As you know, i have slowly begun programming the philips topaz-x machine. For one board that i programmed, everytime i place a board threw the machine, the parts mount differently everytime. The part that I am trying to mount is an ind
Electronics Forum | Fri Nov 14 17:37:58 EST 2008 | snsmt
WHat about bad mounting? i have 2 fixtures and sometimes it would mount with no misalignment and sometimes it would. WHat could be the problem in this case/ I know the fixtures are good because they work on a different program that we have. I don't u
Electronics Forum | Thu Oct 24 03:28:45 EDT 2019 | mfurlandea
Hello, i need an information about Fuji Aimex II and the problem when you have a multi offset pcb and you need to mount some offset with one program and the rest with a different program. So process dispense paste, mounting, changing program and moun