Electronics Forum | Fri Sep 30 07:25:50 EDT 2005 | Gaurav
Hi, How you confirm both V1 & V2 motors are ok?
Electronics Forum | Fri Feb 24 13:44:16 EST 2006 | yiannis
hi, Can anyone tell me there are the switches that configure the RS232 communication with computer ? thnks
Electronics Forum | Tue Mar 14 16:06:14 EST 2006 | Cmiller
Try clicking the equipment mart tab next time you log onto SMTNET.
Electronics Forum | Tue Mar 17 07:22:50 EDT 2009 | pigsinspace
Hi Mark. How did it go? Robert
Electronics Forum | Fri Dec 26 13:35:14 EST 2003 | fpcb
hi, When I start a MPA-80 ( NM 2529T ) I have a 4600 error, ( 1 block stop ) , I check the covers and the pressure : all ok. I monitor the head I/O address 012 and the relative bit 6 is responding when I open the covers. All seem ok BUT the error
Electronics Forum | Mon May 16 11:10:26 EDT 2005 | wizy
I look also for new job in SMT area. Machines what i know: MPM APHie paste printer Simens lines (S23, F5, HS60 etc.) Panasert lines (MV II F, MPA-V, MPA G1, HDP) Omniflow reflow soldering Macrotron and Baasel laser engraver PDT3000 PROM programer
Electronics Forum | Mon Jan 08 01:47:35 EST 2007 | fpcb
hi to all, I have a old MPA-80 machine. I use it for simple boards without problems till now. For a more difficult board I have tried to use command "M801", I think that I have done everything right but I receive a error-message like " x(-)soft
Electronics Forum | Wed Jan 21 06:27:15 EST 2009 | gidster
Seem to be having difficulty with a MPA power source,it powers itself down every now and then. I have changed the relays nc4d and nc2d seems to work for a while but then it rears it's ugly head again, has anybody got any ideas or schematics as the ma
Electronics Forum | Tue Sep 17 12:38:17 EDT 2002 | stepheno
If you have a newer style MPA like the MPA-G3, check out http://www.hoverdavis.com/Products/mpp/mpp.htm I find them much better than the panasonic feeders. You may have to set pitch to 2 or 3 because of timeing issues, or you can change the NC progr
Electronics Forum | Mon Mar 05 10:17:35 EST 2001 | pteerink
We are using an MPAG3 ( similar to MPA-V) in conjunction with a MVIIV. Machines were installed last December. Both machines are very reliable ( avg placement rates over 99% on both machines ). We use Panapro to program, overall it works well, but lik
.gif)
