Electronics Forum | Wed Oct 28 13:29:11 EDT 2009 | swag
Can anyone tell me the command I need to type to get into machine configuration in DOS MpM software? I want to change x/y/theta cal. settings to adjust for vision offset because I don't have the fixtures to do a calibration.
Electronics Forum | Fri May 04 14:47:15 EDT 2007 | jasont
Chris, I have x2 units available in my Brockville, Canada warehouse now. They are off MPM UP 2000 HiE's and the model #'s are as follows; MCU012A-SOO AP25-917A Please e-mail directly at jason@tekmart.com Looking forward to your reply, Jason
Electronics Forum | Tue Aug 29 15:05:16 EDT 2006 | cyber_wolf
We run a lot of double sided boards. So I need a printer that will handle warped boards well. Can anyone tell me which printers work better on warped boards ? Our AP25's are crap on warped boards. If I had a penny for every time our cameras got kno
Electronics Forum | Thu Oct 05 19:00:42 EDT 2006 | SWAG
We've always been MpM so no comparison from me on DEK. All I can say is we have had 3000 series that seemed to need constant attention and almost daily wrenching. We got a couple of AP25 HiE's and they are easier to use, way more reliable and simpl
Electronics Forum | Tue Dec 09 11:40:38 EST 2008 | dwl
Hello, I have an MPM AP 25 and the camera parks itself over the worknest, so when the z tower tries to rise to print, it collides with the camera. Is there some way to adjust the park position so that the camera in not in the way of the Z tower? Than
Electronics Forum | Fri Jul 23 08:31:51 EDT 2004 | pjc
Why don't you contact MPM tech support at 800-737-8110 ?
Electronics Forum | Fri Sep 20 12:32:46 EDT 2002 | cyber_wolf
Can anyone tell me where I might be able to find parts for the vision system on our AP25 printer. In particular I am looking for the cable(s) that go from the camera to the Cognex card. Thanks
Electronics Forum | Fri Oct 28 06:59:45 EDT 2005 | Rob
From what I remember there is a "snap off" setting in the AP25, where you can set the separation speed & I think it may also vibrate the board a little.
Electronics Forum | Mon Jan 12 18:40:32 EST 2004 | fastek
You don't want dedicated tooling. Make sure your machine comes with front and rear dams and plenty of side chucks and magnetic support pins. The best option for these machines is the side snugger option but it doesn't sound like your machine has that
Electronics Forum | Wed Aug 04 21:46:13 EDT 2004 | simmcircuits
Hello Paul, Your Thru Bore calibration worked! Thanks a lot. Cheers, Fyodor