Electronics Forum | Fri Apr 10 20:04:00 EDT 2020 | jlawson
> Fabrication Format. With good tools Like Valor MSS PP you can handle the old (legacy flows) and of course better more modern flows all from one learning library solution = more effective first time right outputs
Electronics Forum | Wed Jun 09 23:58:59 EDT 2021 | SMTA-64387687
The electrical test, on those older machines, wasn't very exact. Try to expand the tolerances, 25-30% for caps and 10% for resistors, and see if that solves your problem. Also, if I remember correctly, if you go into the layout and single-place the c
Electronics Forum | Thu Jun 10 16:40:48 EDT 2021 | cyber_wolf
Yes those verifiers seem like a good idea but they really don't work correctly. You would be better off verifying with a meter during reel changes than wasting your life on that thing. I concur that single mount will show the value.
Electronics Forum | Tue Mar 31 03:12:38 EDT 2020 | sarason
Try PCBSynergy https://pcbsynergy.com If you really need to work from gerber files and not CAD data, use Visualplace https://www.compuphase.com/visualplace/visualplace_en.htm sarason
Electronics Forum | Thu Feb 10 14:27:07 EST 2005 | cyber_wolf
First of all, whom are you getting it from ? Mydata, or a used equipment broker. If you can tell me what machine type you are looking at, then I can tell you what to look for. (MY-series, or TP series) Most important things right off the bat: *Machi
Electronics Forum | Thu Mar 26 13:31:37 EDT 2020 | rgduval
As everyone else said, if you don't have CAD, it's a pain to digitize the gerbers. So much so that we only did it once when I went to CircuitCam training. After you digitize the gerbers, you have to merge the BOM with it. And you have to tell it p
Electronics Forum | Tue Jun 08 22:30:05 EDT 2021 | vtdivtecs
So I am having a little trouble with my mydata MY19. its an older machine picked up used and its had its quirks. recently we tried to start adding electrical verification to our workflow, and had to disable it as we were getting intermittent bad pa
Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Thu Feb 13 09:52:03 EST 2014 | rgduval
Start by getting into the maintenance menu, and manually installing the Servo program for all MOTs. If they install fine, you can check the Z-motor while you're in the maintenance menus. Make sure that the z-locks are unlocked before checking the
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser