Electronics Forum | Thu Aug 08 19:20:08 EDT 2013 | hegemon
I too am hoping a NADCAP guy might jump in here. I would like to know how this portion of the question is handled. Evidence of PM, periodic cleaning of EQ and tools, no issues. Thermocouple calibration? You would think that evidence of Oven CAL
Electronics Forum | Wed Aug 07 16:49:15 EDT 2013 | hegemon
You mean you don't pull all of your thermocouples out of the ovens once a year and send them out for calibration? - lol Tough question. You have a calibrated datalogger. (I assume) You have an oven with preset zone temps, each zone controlled by a
Electronics Forum | Fri Jul 16 15:30:22 EDT 1999 | SMTASSY
Perhaps a little hard to find but is there anyone who uses a vapor phase process to solder populated card with BGAs. I am interested in the success rate of such a process. It is obvious that the throughput is reduce vs a convection oven but still thi
Electronics Forum | Fri Sep 26 12:57:09 EDT 2003 | Angie
We have had some components that popped off in our IR oven. It was attributed to the solder paste. The humidity was above 60% the temp was about 70 degrees.
Electronics Forum | Wed Aug 31 12:33:25 EDT 2005 | Jaya
I have expirence running,double sided Imm gold boards recently which ed up a lot of solderability issue. The Imm gold need to be slightly more control during reflow oven area on it's profile.
Electronics Forum | Tue Feb 19 07:44:41 EST 2008 | tonyamenson
So just to clarify.... If i bought a KIC 2000 I could run that one unit over both my waves and through both my ovens (leaded and lead-free)? Or would I need additional equipment to use it on the wave?
Electronics Forum | Wed Aug 07 12:35:36 EDT 2013 | cyber_wolf
I was asked how we verify that the thermocouples INSIDE the reflow oven are calibrated. That seems pretty impractical to me. Has anyone come across this ?
Electronics Forum | Thu Jul 06 13:36:37 EDT 2006 | SWAG
We've had much trouble with flex circuits. As previously mentioned, you must have local fids for the board or the BGA itself (if panelized). Other troubles we experience are drilled holes for pinned connectors. Unless the PCB manufactur has some w
Electronics Forum | Tue Feb 19 09:41:26 EST 2008 | slthomas
ECD sells the MOLE, and they sell both the Oven Rider and the Wave Rider to accompany it. The thing is, you can profile both an oven and a wave machine without either if you're willing to just solder your thermocouples to a board. The nice thing ab
Electronics Forum | Mon May 07 22:29:52 EDT 2001 | davef
4 wire per sec ... you figure how many you need] Encapsulation ~$120K for a dispenser [10 sec per die ... you figure how many you need] plus a cure oven ~$100k Throw in a another ~$100k for marking and cleaning Check the September 2000 SMTnet New