Electronics Forum | Fri Feb 13 17:55:49 EST 2004 | Dale Freeman
I populate several thin panels (0.032")using a Samsung S-2000 P-N-P machine. With panel sizes of 8" by 10", it is very difficult to clamp the panels into the machine with deflection and bowing. Also, the Samsung makes it very difficult to adjust the
Electronics Forum | Mon Jun 30 00:50:57 EDT 2008 | benefon
Hi There are many ways of doing this but I usually transpose the coordinates to the lower right hand corner of the sub-panel that is situated at the lower right hand corner, because the reference point of the machine is the right hand side locate pi
Electronics Forum | Wed Oct 01 01:15:35 EDT 2008 | benefon
If you have your panel programmed as blocks (as opposed to expanded) two quick ways come to mind: 1. either use block badmarks to mark those blocks that you want to skip or 2. goto Block Repeat Info and mark and set the block that you want to skip as
Electronics Forum | Thu May 01 23:32:46 EDT 2014 | asajedi
I have assembled panels of 24"X9.5" LED Panels (24 strips of 10mm). I need to cut them into strips and join them together then add double sided 3M tape and spool them. How is this best accomplished. Laser Cutting, Die Cutting, Roller Cutting
Electronics Forum | Mon May 13 06:38:41 EDT 2019 | relaycz
You need to give us a little more information. 1. What is the size of your panel? 2. Are there any heavy components? 3. What is the thickness of your board panel? 4. What kind of oven are you using? 5. Is it only a recent problem or ongoing one?
Electronics Forum | Mon Oct 31 19:37:16 EDT 2022 | emeto
Just because you can't add copper to the board, doesn't mean you can't add copper to the panel. Redesign panel, where board house can add copper to the panel to balance the board a little better. I would advise against low melting solder alloys on cu
Electronics Forum | Mon Nov 27 22:01:57 EST 2023 | emeto
It is about thermal mass and heat dissipation. If you want to be accurate, you should profile each one. If you want to be efficient, You should design all panels to come to the same size. This way variation from panel to panel will be minimal (given
Electronics Forum | Wed Sep 15 19:07:39 EDT 1999 | Earl Moon
| | Looking for a manual machine to de-panel with the panels held by 60mm tabs. Each panel hold multi-boards consisting of different shapes and sizes. Scoring is apparently not an option and volume does not dictate a large scale machine. | | | Try
Electronics Forum | Sat Jul 13 09:00:44 EDT 2002 | davef
One of those pick your poison things, eh? * Reduce tester time and labor versus not testing the board after seperation from the panel * Traces that connected to the common bus will have exposed copper after seperation from the panel. This is not rec
Electronics Forum | Thu Jul 25 21:41:03 EDT 2002 | davef
1.0 X-OUT POLICY 1.1 Each Panel not to contain in excess of X% X'd-Out boards. 1.2 Each X-Out board to be marked in a manner so that Pick & Place equipment will not attempt to insert those boards X'd-Out such as fiducial reference hole for paneliz