Electronics Forum | Wed Aug 10 12:22:09 EDT 2005 | jh0n!
Configuration>Parameters>Board Handling "Board stop mounted" was incorrectly checked. Mods, feel free to delete.
Electronics Forum | Sun Dec 25 17:35:06 EST 2005 | Mika
No camera re-calibration is required. Just don't load the deafult calibration parameters. /
Electronics Forum | Wed May 03 11:55:59 EDT 2006 | Chunks
IPC or DFM? Most DFMs are controlled by the equipment restrictions which will define this parameter. "Dross is just abused solder"
Electronics Forum | Mon Aug 07 11:14:38 EDT 2006 | Chunks
You cannot configure or change this parameter. I would suspect your ultra sonic sensor at the begining of the machine is bad.
Electronics Forum | Mon Apr 02 10:23:38 EDT 2007 | realchunks
The parameters are the same as leaded paste. The results are slightly worse.
Electronics Forum | Wed May 21 15:07:34 EDT 2008 | realchunks
I was going to say something - but decided to let it go.
Electronics Forum | Thu May 22 10:18:39 EDT 2008 | slthomas
buzzkill.
Electronics Forum | Tue Jul 29 13:20:55 EDT 2008 | gabriella
330 000ppm on low volume. what is the parameter you are talking about? PPM on AOI?
Electronics Forum | Thu Oct 27 21:50:06 EDT 2011 | dontfeedphils
What sort of coating are you trying to spray? The parameters are going to be drastically different between any two materials.
Electronics Forum | Sat Mar 09 16:14:41 EST 2013 | dilogic
Machine -> Configuration -> Parameters -> Setup then go to vision setup page, if available. - Dejan